Panasonic AWHE60HE, AWHE60SN Jpeg image settings, Image settings, Image capture size QVGA, VGA

Controls and settings from web screen (continued)

JPEG image settings

The image refresh interval (refresh speed), image capture size (resolution) and image quality is set here.

For the settings related to H.264 images, refer to “H.264 image settings”.

H.264 image settings

Set the bit rate, image capture size (resolution), image quality, etc. of the H.264 images for each client.

For the settings related to JPEG images, refer to “JPEG image settings”.

Refresh interval (JPEG)*

[1fps, 2fps, 3fps, 5fps, 6fps, 10fps, 15fps*, 30fps*]

<Initial setting: 10fps>

Select the speed at which the JPEG images are to be refreshed.

Note

ppWhen “On” is selected as the “H.264 transmission” setting and a value with an asterisk (*) is selected, the image refresh interval may become slower than the value which is set.

Image capture size [QVGA, VGA]

<Initial setting: VGA>

QVGA or VGA is selected here as the JPEG image resolution.

Image quality

[0(Highest image quality), 1(High image quality), 2, 3, 4, 5(standard), 6, 7, 8, 9(Low image quality)]

<Initial setting: 5(standard)>

Set the image quality of the JPEG images.

H.264 transmission [On, Off]

<Initial setting: On>

Whether to transmit the H.264 images is set here using On or Off. H.264 transmission can be used by Windows only.

On	H.264 images are transmitted.
Off	H.264 images are not transmitted.

Notes

ppWhen “On” has been selected as the “H.264 transmission” setting, both H.264 images and JPEG images can be displayed on the live screen.

ppWhen “On” has been selected as the “H.264 transmission” setting, the image refresh interval may become slower.

Internet mode (over HTTP) [On, Off] <Initial setting: Off>

This setting is selected when transmitting the H.264 images over the internet. H.264 images can be transmitted using the same broadband router settings as when transmitting JPEG images.

On	The H.264 images are transmitted using the
	HTTP port. For details on setting the HTTP port
	number, refer to page 89.
Off	The H.264 images are transmitted using the
	UDP port.

Notes

ppWhen “On” is set, only “Unicast port (AUTO)” can

be selected as the “Transmission type” setting.

ppWhen “On” is set, it takes a few seconds before the

H.264 images are displayed.

ppWhen “On” is set, the H.264 images may not be displayed, depending on the number of users accessing the unit at the same time.

ppWhen “On” is selected as the “H.264 transmission” setting, the number of users who can access the unit is limited to a maximum of 10.

67