Rockford Fosgate T600-2 OPERATION 2-ChannelWiring, REMOTE PUNCH EQ Option, Punch Eq, Operation

OPERATION

2-Channel Wiring

PASS-THRU

INPUT

REMOTE PUNCH EQ (Option)

NOTE: Use the instructions that came with the remote for a variety of mountings that fit your preference.

Quick Install

1.Using the screws supplied, install the mounting clip.

2.Slip the remote onto the mounting clip until it snaps into place.

3.Route and connect the cable to the remote and amplifier.

Operation

6. Operation works the same as Punch EQ, see below.

	+20
	+18
	+16
	+14
	+12
	+10
	+8
	+6
dB	+4
	+2
	-0
	-2	50	100	200	500	1k	2k	5k	10k	20k
	20
		Bass			Hz				Treble

NOTE: Connecting the optional remote overrides the Punch EQ control on the amplifier.

CAUTION:Overexcursion and subsequent damage may occur at high levels of boost.

PUNCH EQ

This works along with the crossover switch on the amplifier. When set to Low-Pass (LP) operation, this is a variable Bass Boost.

When set to High-Pass (HP) operation, this is a variable Mid-Bass and Treble Boost. When set to All Pass (AP) operation, both the Bass and Treble frequencies are boosted. Set this to your personal preference while listening to the system.

NOTE: Connecting the optional remote overrides the Punch EQ control on the amplifier.

ADJUSTING CROSSOVER FREQUENCY

Placing the crossover switch in the HP position sets the amplifier to the High Pass mode, enabling frequencies above the cut-off point to pass, adjustable between 50-500Hz.

Placing the crossover switch in the AP position sets the amplifier to the All Pass mode, preventing any crossover adjustment, allowing all frequencies to pass.

Placing the crossover switch in the LP position sets the amplifier to the Low Pass mode, enabling frequencies below the cut-off point to pass, adjustable between 50-500Hz.

Turn the crossover adjustment knob all the way down.With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.

8