HeatSeal H410 High Speed 28pp 12/10/04 4:20 pm Page 4
Operation, hot lamination
Connect power cord to appropriate power source.
1Push power button to "ON" position. The green power indicator will illuminate.
2Using the included lamination guide, select appropriate temperature setting for the pouch gauge thickness and material you are laminating.
Temperature Setting Guidelines*
When laminating thin paper with light ink coverage, set the temperature dial at the low end of the range. Thick paper and heavy ink coverage require higher settings within the range. Temperature setting will vary due to the finish, chemistry and heat absorption properties of the material being laminated. If pouch is cloudy the first pass through the machine, adjust temperature higher and run through again. If waviness occurs, reduce the temperature. Always allow sufficient time for laminator to adjust to changes in temperature setting.
3The inside of the laminator will glow red when the laminator has reached operating temperature.
4Position the item to be laminated into a GBC laminating pouch, so that the document is aligned to the folded edge and right and left borders are equal.
5Insert the pouch and its contents straight into the machine, leading with the sealed edge (fig. 1).
6The laminated document will automatically exit the rear of the laminator. After the pouch has stopped moving, place it on a flat surface to cool before handling.
7When you are finished laminating, push the power switch to “OFF”.
Do not laminate an empty pouch.
Operation, cold lamination
Connect power cord to appropriate power source.
1Push power button to “ON” position. The green power indicator will illuminate.
2Turn temperature knob to the cold setting.
3Follow the instructions include with your GBC Self Adhesive laminate or other
Anti-jam feature
How to use the Release Lever (fig. 2)
1Turn off the laminator immediately
2Press the release lever down to release the motor from the rollers
3Pull your document back out of the laminator
4Clean the rollers by running the cleaning sheet supplied with the laminator through the machine 2 or 3 times in hot operation mode. If you do not have this sheet just use or a similar cardboard sheet that fits the width of the laminator
Specifications
| GBC HeatSeal H410 High Speed |
|
|
Electrical | 230V/50Hz/4.2A/1000W |
|
|
Machine Dimensions | 500 x 190 x 114mm |
|
|
Machine Weight | 3.9kg |
|
|
Maximum Pouch Width | 324mm |
|
|
Minimum/Maximum | 2x75 mic. (TOTAL 150) |
Pouch Thickness | 2x125 mic. (TOTAL 250) |
Maximum | 0.7mm |
5 min./2x75 mic. (TOTAL 150)