Toshiba B-SP2D owner manual Picture

Page 24

4. INSTALLING THE PRINTER

EO1-33038

4.1 LOADING THE BATTERY

2)Load a fully charged battery into the printer with the electrode facing down.

NOTE: Load the battery in the correct orientation as indicated in the following

picture.

Battery

Pack

3)Close the battery cover completely.

NOTES:

1.If the battery cover is not completely closed, the battery pack may drop from the printer while it is carried, causing injury.

2.Be careful not to apply excessive force to the battery cover when it is opened, as this may break the battery cover.

■Battery status indication at the power on time

Fully charged:	Flashes in red for a few seconds, and then lights in
	green.
Battery near end:	Flashes in red for a few seconds, and then lights in
	orange.
Low battery:	Flashes in red for a few seconds, and then lights in red.

If the status indicator does not light at all, there may be one of the following problems:

•The battery pack is not loaded.

•The battery is almost dead. (The battery has been excessively discharged.)

•The printer is faulty.

4- 2

Image 24

Contents SP2D Series CE Compliance for EU only VorsichtTrade Mark For all countries and areasFor USA Precaution in use TEC-BTM SpecificationSafety Summary Safety PrecautionsSafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Accessories Applicable ModelP 2 D G H 2 0 -Q M Specifications PrinterBluetooth Interface Serial Interface RS-232CWireless LAN Interface Battery Media Label Tag/Receipt Feed direction Black Mark on reverse sideWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Appearance Front ViewStatus Indicator Red/Orange/Green Power ButtonInterior Operation PanelInstalling the Printer Loading the BatteryPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media General Maintenance CleaningElement Covers Removing Jammed MediaTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C