Toshiba B-SP2D owner manual Ess-Id

Page 35

8. ISSUING THE MEDIA

EO1-33038

8. ISSUING THE MEDIA

1.Turn on the printer.

NOTES:

1.For the GH30 model, pressing and holding the power button causes the printer to automatically issue a label on which the bar code indicating the Bluetooth device address is printed.

2.For the GH40 model, pressing and holding the power button causes the printer to automatically issue a label on which the parameters regarding the wireless LAN, such as, IP address, MAC address, ESS-ID, etc. are printed.

IP Address

ESS-ID

MAC Address

IP Address

8- 2

Image 35

Contents SP2D Series Vorsicht CE Compliance for EU onlyFor all countries and areas Trade MarkFor USA TEC-BTM Specification Precaution in useSafety Precautions Safety SummarySafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction P 2 D G H 2 0 -Q M AccessoriesApplicable Model Printer SpecificationsSerial Interface RS-232C Bluetooth InterfaceWireless LAN Interface Battery Label Tag/Receipt Feed direction Black Mark on reverse side MediaWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Front View AppearanceOperation Panel Status Indicator Red/Orange/GreenPower Button InteriorLoading the Battery Installing the PrinterPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media Cleaning General MaintenanceElement Removing Jammed Media CoversTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C