Toshiba B-SP2D owner manual Connecting the Serial Interface Cable GH20 model only

Page 32

7. CONNECTING THE SERIAL INTERFACE CABLE

EO1-33038

7.CONNECTING THE SERIAL INTERFACE CABLE

7.CONNECTING THE SERIAL INTERFACE CABLE (GH20 model only)

1)Turn off the printer.

2)Place the printer upside down, and connect the serial interface cable to the printer.

3)Secure the serial interface cable tightly to the printer with the cable band. Then, fold back the cable band's end and insert it into any of the openings of the band.

NOTE: If the serial interface cable is still loose, wind it around the cable band one time as shown below.

Serial Interface

CableCable Band

7- 1

Image 32

Contents SP2D Series CE Compliance for EU only VorsichtTrade Mark For all countries and areasFor USA Precaution in use TEC-BTM SpecificationSafety Summary Safety PrecautionsSafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction P 2 D G H 2 0 -Q M AccessoriesApplicable Model Specifications PrinterBluetooth Interface Serial Interface RS-232CWireless LAN Interface Battery Media Label Tag/Receipt Feed direction Black Mark on reverse sideWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Appearance Front ViewStatus Indicator Red/Orange/Green Power ButtonInterior Operation PanelInstalling the Printer Loading the BatteryPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media General Maintenance CleaningElement Covers Removing Jammed MediaTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C