Toshiba B-SP2D owner manual Loading the Media

Page 28

5. LOADING THE MEDIA

EO1-33038

5. LOADING THE MEDIA

5. LOADING THE MEDIA

WARNING!

A cutter is attached to the inside of the media cover. Care should be taken not to injure your hand with the cutter when opening the cover.

This printer prints both labels and receipts.

When loading the media, you do not have to turn off the power.

1.Slide the media cover release catches inside and open the media cover. Media Cover

Media Cover

Release Catch

2.Put a label roll or a receipt roll into the media holder unit in the orientation as shown below.

5- 1

Image 28

Contents SP2D Series CE Compliance for EU only VorsichtTrade Mark For all countries and areasFor USA Precaution in use TEC-BTM SpecificationSafety Summary Safety PrecautionsSafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Applicable Model AccessoriesP 2 D G H 2 0 -Q M Specifications PrinterBluetooth Interface Serial Interface RS-232CWireless LAN Interface Battery Media Label Tag/Receipt Feed direction Black Mark on reverse sideWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Appearance Front ViewStatus Indicator Red/Orange/Green Power ButtonInterior Operation PanelInstalling the Printer Loading the BatteryPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media General Maintenance CleaningElement Covers Removing Jammed MediaTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C