Toshiba B-SP2D owner manual Safety Precautions

Page 7

Safety Precautions

EO1-33038

WARNING

This indicates that there is the risk of death or serious injury if the machines are handled improperly or contrary to this indication.

If water or any other liquid enters the machine, turn off the power. Continuous use of the machine under such conditions may cause fire or electric shock.

If the enclosure is damaged when dropped or subject to shock, turn off the power. Continuous use of the machine under such conditions may cause fire or electric shock.

Avoid continuous exposure to direct sunlight or high temperature as this may cause fire.

Do not remove covers or modify the machine by yourself. Doing so may cause fire or electric shock.

Avoid water, operation with wet hands or cleaning with a moistened cloth. Failure to do this may cause fire or electric shock.

Do not wipe the machine with a cloth moistened with thinner or other volatile solvent as this may cause fire or electric shock.

Use the specified battery only. Failure to do this may cause fire or electric shock.

Danger of explosion if the battery is incorrectly replaced. Replace the battery only with TOSHIBA TEC CORPORATION, Battery Pack Model B-SP2D-BT, 7.4 V 1400 mAh Li-ion.

Discard used batteries according to the manufacturer's instruction.

ATTENTION:

II ya denger d'explosion s'il ya remplacement incorrect de la batterrie. Remplacer uniquement avec une batterie du même type ou d'un type équivalent recommandé par le constructeur.

Mettre au rebut les batteries usagées conformément aux instructions du fabricant.

Do not disassemble and modify the battery because it has a protection unit in it. Doing so may break the protection unit, causing the battery to heat up, burst or burn.

If the battery gets wet, dry it completely. Using a wet battery may cause fire or electric shock.

-v -

Image 7
Contents SP2D Series Vorsicht CE Compliance for EU onlyFor all countries and areas Trade MarkFor USA TEC-BTM Specification Precaution in useSafety Precautions Safety SummarySafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Applicable Model AccessoriesP 2 D G H 2 0 -Q M Printer SpecificationsSerial Interface RS-232C Bluetooth InterfaceWireless LAN Interface Battery Label Tag/Receipt Feed direction Black Mark on reverse side MediaWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Front View AppearanceOperation Panel Status Indicator Red/Orange/GreenPower Button InteriorLoading the Battery Installing the PrinterPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media Cleaning General MaintenanceElement Removing Jammed Media CoversTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C