Toshiba B-SP2D owner manual Strip issue

Page 30

5. LOADING THE MEDIA

EO1-33038

5. LOADING THE MEDIA

•Strip issue

1.Unroll the label roll a little and remove a label.

2.Close the media cover completely. Make sure that the media cover release catches snap back into position.

Media Cover

Release Catch

Media Cover

Release Catch

3.When the label has been loaded in the power on state, the label will be automatically fed to adjust the print start position (only when the feed gap sensor is selected).

NOTE: Be sure to take up any slack in the media roll before closing the media cover. An incompletely closed cover will cause a media skew, print position misalignment, poor print quality, paper jam, etc.

5- 3

Image 30

Contents SP2D Series CE Compliance for EU only VorsichtTrade Mark For all countries and areasFor USA Precaution in use TEC-BTM SpecificationSafety Summary Safety PrecautionsSafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Accessories Applicable ModelP 2 D G H 2 0 -Q M Specifications PrinterBluetooth Interface Serial Interface RS-232CWireless LAN Interface Battery Media Label Tag/Receipt Feed direction Black Mark on reverse sideWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Appearance Front ViewInterior Status Indicator Red/Orange/GreenPower Button Operation PanelInstalling the Printer Loading the BatteryPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media General Maintenance CleaningElement Covers Removing Jammed MediaTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C