Toshiba B-SP2D owner manual Installing the Media Guide

Page 25

4. INSTALLING THE PRINTER

EO1-33038

4.2 INSTALLING THE MEDIA GUIDE

4.2 INSTALLING THE MEDIA GUIDE

WARNING!

A cutter is attached to the inside of the media cover. Care should be taken not to injure your hand with the cutter when opening the cover.

NOTE: The media guides are not required for a 58 mm wide media roll.

1)Slide the media cover release catches inside and open the media cover. Media Cover

Media Cover

Release Catch

2)Fit one media guide into the media holder's edge of the operation panel side, and the other one into a groove which corresponds to the width of media to be used. First insert side (1), then (2) until it snaps in position.

NOTE:Be sure to fit the media guide in parallel with the grooves.

Media Guide

(2)

Operation Panel Side

(1)

Media Holder

4- 3

Image 25

Contents SP2D Series Vorsicht CE Compliance for EU onlyFor all countries and areas Trade MarkFor USA TEC-BTM Specification Precaution in useSafety Precautions Safety SummarySafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Applicable Model AccessoriesP 2 D G H 2 0 -Q M Printer SpecificationsSerial Interface RS-232C Bluetooth InterfaceWireless LAN Interface Battery Label Tag/Receipt Feed direction Black Mark on reverse side MediaWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Front View AppearancePower Button Status Indicator Red/Orange/GreenInterior Operation PanelLoading the Battery Installing the PrinterPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media Cleaning General MaintenanceElement Removing Jammed Media CoversTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C