Toshiba B-SP2D owner manual Issuing the Media

Page 37

8. ISSUING THE MEDIA

EO1-33038

8. ISSUING THE MEDIA

3.Issuing media

•When issuing the labels in batch mode, the number of labels can be specified. To re-issue the labels, press the FEED button.

This operation differs depending on the print mode.

•When issuing the labels in strip mode, the printer prints labels one by one each time the FEED button is pressed.

Before issuing the next label, remove the printed label. This operation differs depending on the print mode.

NOTE: Trim off the backing paper coming from the backing paper outlet.

•When issuing a receipt, press the FEED button after printed to feed it to the position where it is easily cut. Each time the FEED button is pressed, the receipt is fed for 20 mm.

4.Trim off the printed media upward or downward with the cutter.

NOTE: Do not pull the media toward the feed direction, as this will misalign the print position of the next media.

Cutter

8- 4

Image 37

Contents SP2D Series Vorsicht CE Compliance for EU onlyFor all countries and areas Trade MarkFor USA TEC-BTM Specification Precaution in useSafety Precautions Safety SummarySafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Applicable Model AccessoriesP 2 D G H 2 0 -Q M Printer SpecificationsSerial Interface RS-232C Bluetooth InterfaceWireless LAN Interface Battery Label Tag/Receipt Feed direction Black Mark on reverse side MediaWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Front View AppearancePower Button Status Indicator Red/Orange/GreenInterior Operation PanelLoading the Battery Installing the PrinterPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media Cleaning General MaintenanceElement Removing Jammed Media CoversTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C