Toshiba B-SP2D owner manual Precautions

Page 9

Safety Precautions

EO1-33038

Do not charge the battery near flame or under direct sunlight. High temperature may activate or damage the protection unit of the battery, disabling the electric charge or causing it to overheat, burst, or burn.

Unload the battery when the machine will not be used for a long time. Failure to do this may cause machine failure.

Keep the battery away from flame, a heat source or other locations subject to high temperature.

Failure to do this may cause it to over heat or burn.

Use the specified battery charger only. Failure to do this may cause the battery to overheat, burst or burn.

Do not force the battery into the machine or battery charger. Doing so may cause the battery to overheat, burst or burn. Check for the correctelectrode.

Do not connect the battery to a power outlet or a car cigarette lighter jack as this may cause the battery to overheat, burst or burn.

Because the B-SP2D-BT battery is exclusively for the B-SP2D printer, do not use the battery in other machines. Doing so may damage the battery or affect the performance and life of the battery.

Precautions

The following precautions will help to ensure that this machine will continue to function correctly.

(1)Try to avoid locations that have the following adverse conditions:

*Temperatures below -5°C and above 40°C

*Direct sunlight

*Excessive vibration

(2)The cover should be cleaned by wiping with a dry cloth or a cloth slightly dampened with a mild detergent solution. NEVER USE THINNER OR ANY OTHER VOLATILE SOLVENT on the plastic covers.

(3)USE ONLY TOSHIBA TEC SPECIFIED media.

- vii -

Image 9
Contents SP2D Series Vorsicht CE Compliance for EU onlyFor all countries and areas Trade MarkFor USA TEC-BTM Specification Precaution in useSafety Precautions Safety SummarySafety Precautions Safety Precautions Precautions Safety Precautions Table of Contents Connecting the Serial Interface Cable Introduction Accessories Applicable ModelP 2 D G H 2 0 -Q M Printer SpecificationsSerial Interface RS-232C Bluetooth InterfaceWireless LAN Interface Battery Label Tag/Receipt Feed direction Black Mark on reverse side MediaWidth 49, 52, 55, 58 ±0.5 Note Media width 25.0 − 55.0 Note Front View AppearancePower Button Status Indicator Red/Orange/GreenInterior Operation PanelLoading the Battery Installing the PrinterPicture Installing the Media Guide Installing the Printer Installing the Media Guide for Outside Wound Paper Loading the Media Batch issue Strip issue Securing the Printer to Your Waist Connecting the Serial Interface Cable GH20 model only Connecting the Serial Interface Cable Issuing the Media ESS-ID IrDA Communication Sample Issuing the Media CARE/HANDLING of the Media Cleaning General MaintenanceElement Removing Jammed Media CoversTroubleshooting Cause Corrective action Turn on the power Interface cable One minute after power Other problems Cause Corrective action Wireless LAN Release catches are not Page EO1-33038C