Troubleshooting
Symptom | Diagnosis |
| Remedy |
| |||
|
|
|
|
Amplifier does not | B+ or REM not between 10.5 and |
| Check the alternator, battery, fuse, |
turn on. | 15.5 volts or no voltage present |
| and wiring and repair as necessary |
|
|
|
|
Amplifier Noise | Amplifier is not properly grounded. |
| Check wiring and repair as necessary |
|
| ||
|
|
|
|
| Voltage spike from source unit is |
| Connect a relay |
| entering amplifier’s input |
| REM terminal if pops are eliminated |
|
|
| with no input signal to amplifier |
|
|
|
|
Engine Noise | Noise is radiating into signal cables |
| |
|
| ||
|
|
| sources of high current |
|
|
|
|
Specifications
MODEL- Storm | X1.1000.1D | X1.2000.1D | X1.400.2 |
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
X1.800.4
4Ω Load Per Channel | 400 Watts x 1 |
2Ω Load Per Channel | 700 Watts x 1 |
4Ω Load Bridged (Mono) |
|
X1.1000.1D & X1.2000.1D Only |
|
1Ω Load Bridged | 1000 Watts x 1 |
Dimensions: -
add 1.5" (xcm) to length for mounting feet
Height | 2.2" (5.6cm) |
Width | 10.4" (26.42cm) |
Length | 14" (35.56cm) |
700 Watts x 1
1200 Watts x 1
2000 Watts x 1
2.2" (5.6cm)
10.4" (26.42cm) 22.0" (56.00cm)
100 Watts x 2
200 Watts x 2
400 Watts x 1
2.2" (5.6cm)
10.4" (26.42cm) 15.2" (30.61cm)
100 Watts x 4
200 Watts x 4
400 Watts x 2
2.2" (5.6cm)
10.4" (26.42cm) 18.6" (47.24cm)
>90dB | |
Input Sensitivity | 150mV - 4V |
Crossover (X1.1000.1D & X1.2000.1D only) | 24dB/octave Low Pass only |
Crossover (X1.400.2 & X1.800.4 only) | 24dB/octave HPF/Flat/LPF Switch |
Crossover Frequency | variable from 50Hz to 250Hz |
Channel Separation | 50dB |
Bass Equalization (X1.1000.1D & X1.2000.1D only) | Variable from 0dB to +12dB @ |
Specifications subject to change without notice
12