Toshiba VF-MB1/S15 instruction manual ZSW Status Word Data, Bit Valure Name

E6581738

3.3.ZSW Status Word Data

Bit	Valure	Name	Note
0	1	Ready To Switch-on	Power supply is switched on
	0	Not Ready To Switch-on	-
1	1	Ready To Operate	Refer to control word, bit 1.
	0	Not Ready To Operate	-
	1	Operation Enabled	Drive follows setpoint.
2			(Refer to control word 1, bit 3)
	0	Operation Disabled	-
3	1	Fault Present	VF-MB1/S15 tripped.
	0	No Fault	VF-MB1/S15 is not tripped.
4	1	Coast Stop Not Activated	-
	0	Coast Stop Activated (OFF 2)	"Coast Stop (OFF 2)" command is present.
5	1	Quick Stop Not Activated	-
	0	Quick Stop Activated (OFF 3)	"Quick Stop (OFF 3)" command is present
	1	Switching On Inhibited	Control word bit1 or 2 is set to 0
6			or fault trip has been acknowledged.
	0	Switching On Not Inhibited	-
	1	Warning Present	Drive still operational: Alarm in service parameter: No
7			acknowledgement.
	0	No Warning	Alarm not present or alarm has disappeared again
	1	Speed Error	Refer to section 3.3.1.
8		Within Tolerance Range
	0	Speed Error
		Out Of Tolerance Range
9	1	Control Requested	VF-MB1/S15 is controlled by PROFIBUS master.
	0	No Control Requested	VF-MB1/S15 is controlled by another interface.
10	1	f Or n Reached Or Exceeded	Actual value ≥ Comparison value (setpoint)
	0	f Or n Not Reached	-
11	----	Device-specification	(Reserved.)
12	----	Device-specification	(Reserved.)
13	----	Device-specification	(Reserved.)
14	----	Device-specification	(Reserved.)
15	----	Device-specification	(Reserved.)

- 11 -