Airlink CDMA/1x manual UDP Pad Mode, UDP Auto Answer

Host Modes

SLIP does not negotiate the IP with the host, so before making a SLIP connection, the host SLIP driver must be configured to use the IP specified by querying S110.

UDP Pad Mode

When the modem is in UDP PAD (Packet Assembly and Disassembly) Mode, all characters received on the serial port are assembled into UDP packets and sent to the Raven’s remote IP address/port, and any packets received from the same IP/ port-destined for the Raven’s Device Port (see *DPORT)--are disassembled and dumped onto the serial line.

A UDP session is initiated by one of the following events:

•Using the Dial UDP (DP) AT command (ex. ATDP192.168.3.23/3456)

•Setting the Startup Mode Default (MD) to 3 (UDP) so that a UDP session is entered automatically when the modem powers up. Serial data will be sent to the IP/port specified in S53.

•An incoming UDP packet is received and

•UDP auto answer is enabled (S82=2);

•The destination IP address matches that in S53;

•Or allow any IP is set (AIP=1);

•The modem is in AT mode (not in a current UDP or TCP session).

•• • • UDP packet assembly is affected by the values of S50 (PAD Forwarding Time-out) and S51 (PAD Forwarding Character). Data received in the serial buffer will be transmitted when the idle inter-character time-out specified in S50 (in tenths of seconds) occurs or when a character is received that matches S51 (if non-zero).

UDP Auto Answer

UDP auto answer (previously called UDP half-open) is set with S82=2. When set, the Raven will automatically establish a UDP session to the source IP address and port of the UDP packet received. The Raven will remain "locked" to this one remote IP/port until no data is sent or received for the time interval defined in the UDP auto answer time-out (S83). During this session, packets from other IP/port addresses will be rejected, unless *UALL is set. Whether or not an incoming packet will cause the modem to enter a UDP session is always dependent on the S53 and AIP settings.

Raven CDMA User Guide for Verizon, version 2.23 27