Airlink CDMA/1x manual Activation

TABLE 3. Basic Commands (common AT commands)

Command	Parameters	Details
Qn	n=0 or 1	The AT quiet-mode setting. If quiet mode is set, there
		will be no responses to AT commands except for data
		queried.
		0	: Off (Default)
		1	: Quiet-mode on
Vn	n=0 or 1	Command Response Mode.
		0	: Terse (numeric) command responses
		1	: Verbose command responses (Default).
Xn	n=0 or 1	Extended Call Progress Result mode.
		0	: Turn off extended result codes (Default).
		1	: Turn on result codes. This adds the text 19200 to the
		CONNECT response.
Z	none	Reset the Raven.
		Note: This command does nothing if *DATZ=1.
&F	none	Restore Factory Setting.
&W	none	Writes all changed modem settings. If this command is
		not issued, any modified values will revert back to their
		previous values at modem reset.
*DATZ=n	n=0 or 1	Enables or disables reset on ATZ.
		0	: Normal Reset (Default)
		1	: Disable Reset on ATZ

Activation

The preferred method of activating (provisioning) the modem is using the Setup Wizard. However, there are special circumstances when commands may be used instead.

Caution: You may need go into PassThru mode to use some of the commeands in this section to activate the Raven.

62 Raven CDMA User Guide for Verizon, version 2.23