Airlink CDMA/1x manual Local Network and Host Modes, This command is not pro Ceeded by AT

TABLE 6. Local Network and Host Modes

Command	Parameters	Details
+++	none	AT Escape sequence.
		If the Raven is in a data mode (any mode other than
The "+" is ASCII 0x2B.		PassThru), this command causes the modem to re-enter
		AT command mode.
This command is not pro-
		Note: There must be an idle time (set by S50) on the
ceeded by AT.
		serial port before and after this command. The detection
		of +++ is disabled if DAE=1.
AIP=n	n=0	Allow only the IP specified in S53 to connect when UDP
		auto answer is enabled (S82=2).
		Allow any incoming IP to connect when UDP auto
	n=1	answer is enabled (S82=2).
		Always subject to any Friends filters that may be
		defined.
HOR=n		Half-Open Response - In UDP auto answer (half-open)
		mode:
	n=0	No response codes when UDP session is initiated.
		RING CONNECT response codes sent out serial link
	n=1	before the data from the first UDP packet.
		Note: Quiet Mode must be Off.
MDhh	hh (hex byte) =	Default power-up mode.
	00 - normal	When the PinPoint is power-cycled, it may enter the
	mode	mode specified by this command after 5 seconds. On
	01 - SLIP mode	startup, typing ATMD0 within 5 seconds changes the
		mode to normal (AT command) mode.
	02 - PPP mode
		See also S53 to set the port for UDP or TCP.
	03 - UDP mode
	04 - TCP mode
	07 - PassThru
	mode

66 Raven CDMA User Guide for Verizon, version 2.23