Airlink CDMA/1x manual Activation Provisioning

TABLE 4. Activation (Provisioning)

Command	Parameters	Details
OPRG=n	n=0 or 1	Enables/disables over-the-air firmware upgrading of the
		Raven.
		0 : Disables over-the-air programming.
		1 : Enables over-the-air programming.
*DEVICEID=n	n=number string	Sets or queries the 64-bit Device ID that is used by the
		modem to identify itself to the server. The default is a
		value that depends on the underlying communications
		technology being used.
*NETPHONE?	none Aucun	The modem's phone number, if applicable or obtainable.
*NETPW=pw	pw=password	The password that is used to login to Verizon’s cellular
		network, when required.
*NETUID=uid	uid=user id (up	The login that is used to login to the Verizon’s cellular
	to 64 bytes)	network, when required.
*NETROAMPREF=n	n=0 or 1	Allow configuration of the roaming preference.
		0 : Restrict to home network only.
		1 : Allow roaming to affiliated networks.
*PROVISION=	MSL=master	Provision the modem with the lock code and phone num-
[MSL],[MDN/MIN],[SID],	lockcode	ber.
[NID]	MDN/MIN=	Note: It is recommended to use the Verizon Setup Wiz-
	phone number	ard for Verizon to provision the modem. *Note: Verizon
	SID=network	may not support this function.
	ID*
	NID=system
	ID*
*PROVISION2=	Same as above	A second set of modem provision parameters, when the
[MSL],[MDN],[MIN],[SID],	but with MDN	MDN and MIN (MSID) are different or “split”.
[NID]	and MIN “split”	Note: SID and NID are optional, however if you include
		SID you must include NID.
*STATICIP=d.d.d.d	d.d.d.d=IP	Set the static IP required to be received from the net-
		work. If the modem does not get this IP address from the
		network, it will reset the module and try again. The
		default is 0.0.0.0, which allows any IP address from the
		network. Example: AT*STATICIP=192.168.1.23

Raven CDMA User Guide for Verizon, version 2.23 63