Airlink CDMA/1x manual Friends Mode, Fn=d.d.d.d, DNSn=d.d.d.d

Page 83

Friends Mode

Friends Mode can limit access to the Raven from the Carrier network and the Inter- net. Friends Mode is a limited form of security.

TABLE 11. Friends Mode

Command

Parameters

Details

 

 

 

FM=[n]

n=0 or 1

Friends Mode - Only allow specified IPs to access the

 

 

Raven.

 

 

0 : Disable Friends mode

 

 

1 : Enable Friends mode - Only packets from friends will

 

 

be accepted (see below); packets from other IP addresses

 

 

are ignored.

 

 

 

Fn=[d.d.d.d]

n = Friends list

Friends mode IP address.

 

index [0 - 9]

255 = allow any number 0-255

 

d.d.d.d = IP

 

Example: 166.129.2.255 allows access by all IPs in the

 

address

 

range 166.129.2.0-166.129.2.255.

 

 

 

 

Note: ATF? will return a list of all the current Fn set-

 

 

tings.

 

 

 

DNS

DNS settings in the Raven allow the modem to use domain names instead of IPs to contact other Internet hosts.

TABLE 12. DNS

Command

Parameters

Details

 

 

 

*DNSn=d.d.d.d

n=1 or 2

Sets the DNS addresses to be returned during PPP nego-

 

d.d.d.d = IP of

tiation. If the underlying communications network pro-

 

vides DNS addresses, they replace those specified by

 

domain server

 

this command.

 

 

 

 

You can only set *DNS1 and *DNS2.

 

 

 

Raven CDMA User Guide for Verizon, version 2.23

77

Image 83
Contents User Guide Raven Cdma User Guide for Verizon, version Contents TCP PAD Mode DNS Using Names Instead of IP addressesConfiguring Keepalive Data usage using Keepalive AT Mode PassThru Mode PPP Mode Slip Mode UDP Pad ModeSnmp Overview Appendix 1 Specifications for the Raven CdmaRaven Snmp Configuration Connecting the Antenna Connecting powerSupport web site Contacting Technical Support What is RSSI? Why is the Rssi for my Raven negative?Appendix 4 Example of the MIB trap Introduction to Raven Cdma Establishing a Internet Connection Cdma OverviewUsing Cdma to Communicate with Your Equipment Financial Point of Sale and Kiosk Common Uses for the RavenBackup connection to the Internet Activation of the Raven Connecting the Raven to your computerQuick Start Guide and Setup Wizard Setup Wizard Raven Indicator Lights Activating the Raven using AT CommandsRaven Cdma User Guide for Verizon, version Utilities for the Raven Wireless ACE 3G AirLink Configuration Executive ACEAceView AceNetAceView About Modem Modem Doctor IP Manager Fully Qualified Domain Name Dynamic Name ResolutionConfiguring the Raven for Dynamic IP Restrictions for Modem Name Wireless ACE Dynamic IP IP Manager configurationConfiguring DNS DNS Using Names Instead of IP addressesPPP-Peer Keepalive Configuring KeepaliveWireless ACE Keepalive Configuration Data usage using KeepaliveHost Modes AT Mode PassThru Mode ATDT10.0.0.1CR ATDT10001CR ATD#19788CR PPP ModeSlip Mode UDP Auto Answer UDP Pad ModeReliable UDP Multicast UDP TCP PAD ModeTCP Auto Answer Hybrid ModesHybrid Mode Settings Modbus Overview Modbus/BSAP ConfigurationProgrammable Logic Controller PLC TelemetryRemote Terminal Unit RTU Supervisory Control and Data Acquisition ScadaRaven Modbus on UDP Modbus TCP/IPPort Configuring the Raven at the Polling Host for Modbus on UDPDefault Power-up Mode Dynamic IP IDs to IPsWireless ACE Modem Name and Domain Configuring the Remote Ravens for Modbus withDynamic IPs Host Raven IPRaven mounted in an enclosure with an RTU RTU settingsRTU to Raven setup Snmp Overview Simple Network Management Protocol SnmpListening Port Raven Snmp ConfigurationManagement Information Base MIB Snmp TrapsSecurity Level User Name and PasswordWireless ACE Changing the Raven Password Menu Option Trap Destination Connecting the Antenna Hardware InstallationConnecting the Raven to a computer or other device Connecting powerEnvironmental Specifications for the Raven CdmaPhysical Characteristics Data Services & RF Features CdmaSerial Port Pin-outs Power ManagementPower consumption Raven Cdma User Guide for Verizon, version Raven Mounting Bracket, part number 100-170-1009 a Mounting KitRaven Cdma User Guide for Verizon, version Using Wireless Ace AT CommandsWireless ACE Using AT Commands Using Telnet Terminal EmulationStartAll ProgramsAccessoriesCommunicationsHyperTerminal Direct Serial Connection HyperTerminal AT mode via TelnetHyperTerminal Comport Setting AT Command TablesInformation Commands Information and Status Command DetailsRaven None Basic CommandsBasic Commands common AT commands Activation Activation Provisioning Cellular Network Verizon’s Cdma Cellular NetworkPassThru Local Network and Host ModesLocal Network and Host Modes This command is not pro Ceeded by ATStopbits = S23=speed,databits Speed =Paritystop bits Databits = 7 or Itystop bits Parity =Figured to ignore DTR. When Ignore DTR is enabled Slip Default N.n = subnet AtdtPPP Direct Communication Telnet When *CSX1=0Direct Communication Port S53=methodd.d.d.d Method =Ppppp Hhmmss = Time and DateMm/dd/yyyy = Yyyy,hhmmssDNSn=d.d.d.d Friends ModeFriends Mode Fn=d.d.d.dKeepalive If *DOMAIN=eairlink.com, then when IP ManagerExample if *MODEMNAME=mymodem Raven Cdma User Guide for Verizon, version Modbus LoggingD.d=IP or Modbus SettingsCannot be configured in Wireless ACE MLISTid=d.d.d.dLow order 4 bits D.d = IP or Snmp Simple Network Management ProtocolSMTP/SMS Name= Smtp email and SMS messagingNumber= SMS NumberFlag=2 Index=0-9C3211 Flag=0 Flag=1Other Other Settings AIRLINK-MIB Definitions = Begin Imports Example of the MIB trapRaven Cdma User Guide for Verizon, version Raven Cdma User Guide for Verizon, version Raven Cdma User Guide for Verizon, version Raven Cdma User Guide for Verizon, version Raven Cdma User Guide for Verizon, version Raven Cdma User Guide for Verizon, version END Raven Cdma User Guide for Verizon, version What is RSSI? Why is the Rssi for my Raven negative? Frequently Asked Questions FAQ and SolutionsDipole What is the Proper RF Coverage for my Raven?What Type of Antenna is Best for my Raven? Dual-bandMounts What do I need to power my Raven ?Can I use a portable battery to power my Raven ? 103 Private Mode *HOSTPRIVMODE=1 Public Mode *HOSTPRIVMODE=0105 What is the COM1000?Wireless ACE Update PRL Wireless ACEAT Commands Wireless ACE Update PRL interface108 Contacting Technical Support Support web site