Airlink CDMA/1x manual S23=speed,databits Speed =, Paritystop bits, Stopbits =

TABLE 6. Local Network and Host Modes

Command	Parameters	Details
S0=n	n=0 1 2 3	This register determines how the Raven responds to an
		incoming TCP connection request. The Raven remains
		in AT Command mode until a connection request is
		received. DTR must be asserted (S211=1 or &D0) and
		the Raven must be set for a successful TCP connection.
		The modem will send a "RING" string to the host. A
		"CONNECT" sent to the host indicates acknowledge-
		ment of the connection request and the TCP session is
		established.
		0 : Off (Default)
		1 : On
		2 : Use Telnet server mode on TCP connections.
		3 : With a Telnet connection, overrides the client's
		default echo, allowing the server on the host port to per-
		form the echo. CRLF sequences from the telnet client
		will also be edited to simply pass CRs to the server on
		the host port.
S7=n	n = seconds	Specifies the number of seconds to wait for a TCP con-
		nection to be established when dialing out.
S23=[speed],[databits]	speed =	Serial line parameters. The settings take affect after
[parity][stop bits]	300 1200	reset.
		Ex. ATS23=19200,8N1 (sets modem to 19200, etc.)
	2400 4800
	9600 19200	Note: Databits MUST be 8 data bits for PPP mode.
	38400 57600
		Can also be set using &L=[speed],[databits] [par-
	115200 230400
	databits = 7 or 8	ity][stop bits]
	parity =	O=Odd E=Even N=None M=Mark
	O E N M
	stopbits =
	1 1.5 2
S50=n	n = tenths of	Data forwarding idle time-out. If set to 0, a forwarding
	seconds	time-out of 10ms is used.
		(Used in UDP or TCP PAD mode)

Raven CDMA User Guide for Verizon, version 2.23 67