Airlink CDMA/1x manual Slip Default

TABLE 6. Local Network and Host Modes

Command	Parameters	Details
TCPS=n	n = minutes	TCP connection time-out (TCPS) units. Specifies a time
	(TCPS=0) or	interval upon which if there is no in or outbound traffic
	seconds	through a TCP connection, the connection will be termi-
	(TCPS=1)	nated.
TCPT=n	n = minutes	TCP connection time-out (TCPT) units. Specifies a time
	(TCPT=0) or	interval upon which if there is no in or outbound traffic
	seconds	through a TCP connection, the connection will be termi-
	(TCPT=1)	nated.
		This value only affects the TCP connection in TCP PAD
		mode.
&Cn	n=0 1 2	Set DCD mode.
		0 : Always assert DCD.
		1 : Assert DCD when in a data mode (UDP, TCP, PPP, or
		SLIP) (Default).
		2 : Assert DCD when the modem has network coverage.
&Dn	n=0 or 2	Set DTR mode.
		0 : Ignore DTR, same effect as HW DTR always
		asserted (same as S211=1).
		2 : Use hardware DTR (same as S211=0).
&Sn	n=0 1 2	Set DSR mode.
		0 : Always assert DSR.
		1 : Assert DSR when in a data mode (UDP, TCP, PPP, or
		SLIP) (Default).
		2 : Assert DSR when the modem has network coverage.
		Note: S211 can also be used to request that DSR is
		always asserted. If S211 is set to 3 and &S is changed to
		a non-zero value, S211 will be changed to 1.

Raven CDMA User Guide for Verizon, version 2.23 69