Airlink CDMA/1x manual Telnet, When *CSX1=0

TABLE 7. PassThru Mode

Command	Parameters	Details
\APASSTHRU	none	Set modem operation to pass through mode. This will
		pass any characters received on the serial port directly to
		the internal hardware module and output any characters
		from the internal hardware module out the serial port.
Note: This mode is not		This allows direct access/configuration of the hardware
available through the remote		module. Once this mode is entered, the unit must be
AT telnet server.		physically reset to return to normal operation.
		Note: It may take up to 30 seconds for the hardware
		module to respond after CONNECT is output.
*CSX1=n	n=0 or 1	0 : Data will be passed to the host.
		1 : PASSTHRU mode will echo all host received data
		and will not pass the data to the modem while the
		modem is not asserting DCD.
		Note: If the modem is asserting DCD, data will be
		passed from the host to the modem as it normally is
		when *CSX1=0.
*PTINIT=n	n=AT command	Any AT Command string to be passed to the OEM mod-
		ule before entering PASSTHRU mode, e.g. AT&S1V1,
		etc.
*PTREFRESH=n	n=0-255 min-	Number of minutes of inactivity in PASSTHRU mode to
	utes	resend the *PTINIT string to the hardware module.
		0 : Disabled
*RESETPERIOD=n	n=0-255 hours	In PASSTHRU mode, modem will be reset after this
		period if no data has been sent or received. . Value is in
		hours.
		0 : Disabled

Telnet

It is possible to communicate with the Raven across a TCP/IP network. Telnet pro- vides a terminal style connection to the Raven.

Raven CDMA User Guide for Verizon, version 2.23 73