Airlink CDMA/1x manual Ppp

TABLE 6. Local Network and Host Modes

Command	Parameters	Details
*HOSTPEERIP =d.d.d.d	d.d.d.d=local or	Set or query the IP address that can be used to directly
	peer IP of	contact the Raven once a PPP connection is established.
	modem	If this value is not specified, 192.168.13.31 will be used.
		Note: This is not normally used nor needed by user
		applications. PPP
*HOSTPRIVIP =d.d.d.d	d.d.d.d=IP	Set or query the private IP address that is to be negoti-
		ated by the PPP connection if *HOSTPRIVMODE =1.
		PPP
*HOSTPRIVMODE =n	n=0 or 1	Set or query whether a private or public (network) IP is
		to be used when the Host initiates a PPP connection to
		the modem. PPP
		0 : Public (network) IP Mode: When the Host initiates a
		PPP connection, the host will be given the public IP that
		was obtained from the OEM module. If the network
		issues a new IP, the PPP connection will be closed (since
		the IP has changed) and has to be re-initiated. (default).
		PPPPPP
		1 : Private IP Mode: When the Host initiates a PPP con-
		nection, the host will be given the IP address specified in
		*HOSTPRIVIP. The modem will then perform NAT-like
		address translation, which shields the Host from network
		IP changes. PPP
*MODEMHISPEED=n	n=0 or 1	Set the internal serial link speed to the radio (modem)
		module.
		0 : 115200 (default)
		1 : 230400
*UALL=n	n=0 or 1	Accepts UDP packets from any IP address when a UDP
		session is active. If there is no UDP session active, an
		incoming UDP packet will be treated according to the
		UDP auto answer and AIP settings.
		0 : No effect (Default).
		1 : Accept UDP data from all IP addresses when in a
		UDP session.

Raven CDMA User Guide for Verizon, version 2.23 71