Samsung CLX-3175FN, CLX-3175FW, CLX-3175N, CLX-3170FN manual Safety information10

Page 106

RINGER EQUIVALENCE NUMBER

The Ringer Equivalence Number and FCC Registration Number for this machine may be found on the label located on the bottom or rear of the machine. In some instances you may need to provide these numbers to the telephone company.

The Ringer Equivalence Number (REN) is a measure of the electrical load placed on the telephone line, and is useful for determining whether you have “overloaded” the line. Installing several types of equipment on the same telephone line may result in problems making and receiving telephone calls, especially ringing when your line is called. The sum of all Ringer Equivalence Numbers of the equipment on your telephone line should be less than five in order to assure proper service from the telephone company. In some cases, a sum of five may not be usable on your line. If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line, as it may cause harm to the telephone network.

FCC Regulations state that changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. In the event that terminal equipment causes harm to the telephone network, the telephone company should notify the customer that service may be stopped. However, where prior notice is impractical, the company may temporarily cease service, providing that they:

a)promptly notify the customer.

b)give the customer an opportunity to correct the equipment problem.

c)inform the customer of the right to bring a complaint to the Federal Communication Commission pursuant to procedures set out in FCC Rules and Regulations Subpart E of Part 68.

You should also know that:

Your machine is not designed to be connected to a digital PBX system.

If you intend to use a computer modem or fax modem on the same phone line as your machine, you may experience transmission and reception problems with all the equipment. It is recommended that no other equipment, except for a regular telephone, share the line with your machine.

If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for both the power and the telephone lines. Surge protectors can be purchased from your dealer or telephone and electronic specialty stores.

When programming emergency numbers and/or making test calls to emergency numbers, use a non-emergency number to advise the emergency service dispatcher of your intentions. The dispatcher will give you further instructions on how to actually test the emergency number.

This machine may not be used on coin service or party lines.

This machine provides magnetic coupling to hearing aids.

You may safely connect this equipment to the telephone network by means of a standard modular jack, USOC RJ-11C.

Safety information_10

Image 106
Contents Multi Functional Printer Features of your new laser product Special FeaturesAbout this USER’S Guide Features by ModelsFeatures Convention Description ExampleOnline User’s Guide Quick Install GuideFinding More Information Printer Driver HelpImportant Safety Symbols and Precautions Safety informationWhat the icons and signs in this user’s guide mean Laser Safety Statement Power Saver Ozone SafetyMercury Safety RecyclingFAX Branding FCC Statement for Wireless LAN useUnited States of America Canadian Radio Interference RegulationsRinger Equivalence Number You should also know thatApprovals and Certifications Replacing the Fitted Plug for UK onlyDeclaration of Conformity European Countries EC CertificationEuropean States qualified under wireless approvals EEA/EFTA countriesWireless Guidance Regulatory Compliance StatementsOpenssl License Original Ssleay License14Safety information Safety information15 Contents Scanning by a network connection Printing a document Canceling a print job Sending a faxFax setup Receiving a faxBacking up data Solving other problemsPrinting from a USB memory device Managing USB memoryHow to purchase Fax problemsCommon Linux problems General specificationsMachine Overview IntroductionFront view Rear view Control Panel Overview Acknowledging the Status of the Toner Cartridge Understanding the Status LEDStatus Description Menu Overview Darkness SendingFeature Windows Linux Macintosh Printer Driver FeaturesContents Supplied SoftwareSetting UP the Hardware Getting startedMacintosh System RequirementsWindows LinuxUsing the SetIP program Setting UP the NetworkConfiguring network protocol via the machine Supported operating environmentsInstalling the Software Custom mode Using a Wireless NETWORKCLX-3175FW onlyWizard mode Hexadecimal Format Ascii FormatOperation Mode is Infrastructure Configuring wireless network from syncthru web serviceSelect Network NameSSID in Ssid Setup Operation Mode is Ad-hocMachines Basic Settings Entering characters using the number keypad Using the save modesAuto continue On the scanner glass Loading originals and print mediaLoading Originals ADFSelecting Print Media Specifications on print media Type Size Dimensions Weighta CapacitybGuidelines for special print media Media sizes supported in each modeMode Size Source Media Type GuidelinesPreprinted Changing the Size of the Paper in the Paper TrayPaper Slide the tray 1 back into the machine Printing on Special Print Materials Setting the Paper Size and TypeFeeding the print material manually Copying Changing the Settings for Each CopyCopying ID Card Copying Changing the Default Copy SettingsUsing Special Copy Features Up or 4-up copyingErasing background images Setting Copy TimeoutClone copying Gray enhance copyingScanning Basics Setting scan information in Samsung Scan ManagerScanning Scanning from the Control PanelScanning by a Network Connection Setting up an e-mail accountClick Machine Settings and User Authentication Scanning to EmailChanging the Default Scan Settings Changing the Settings for Each Scan JOBSetting UP Address Book Printing Address Book Searching with a particular first letterScanning Basic printing Canceling a Print JOBPrinting a Document Resolution Setting the fax headerAdjusting the document settings FaxingConfirming a transmission Sending a fax automaticallySending a fax manually Automatic redialingCanceling a delayed fax Sending a delayed faxAdding pages to a delayed fax Sending a priority faxReceiving a FAX Receiving faxes in memory Receiving in secure receiving modeActivating secure receiving mode Forwarding faxesForwarding received faxes to email address FAX SetupChanging the fax setup options Sending optionsPrinting sent fax report automatically Changing the default document settingsSetting up Address Book Speed dial numbersDeleting a Address Book entry Group dial numbersSearching Address Book for an entry Printing Address BookPlugging in a USB Memory Device Using USB memory deviceAbout USB Memory Scanning to a USB Memory DevicePrinting from a USB Memory Device Backing UP DataDeleting an image file Managing USB MemoryPrinting Directly from a Digital Camera Formatting a USB memory devicePrinting Reports MaintenanceAdjusting the Color Contrast Printing a reportCleaning the inside Cleaning Your MachineCleaning the outside Clearing MemoryMaintenance Cleaning the scan unit White sheet ADF Sheet Scanner glass Scanner lidToner cartridge storage Maintaining the CartridgeReplacing the Toner Cartridge Expected cartridge lifeMaintenance Replacing the Imaging Unit Replacing the Waste Toner Container Managing Your Machine from the Website Maintenance PartsTo access SyncThru Web Service Checking the MACHINE’S Serial NumberClearing Document Jams TroubleshootingTips for Avoiding Paper Jams Exit misfeedTray Clearing Paper JamsRoller misfeed Fuser unit areaPaper exit area Fuser leverTroubleshooting Meaning Suggested Solutions Understanding Display MessagesNot Assigned Page/Cancel Job Network ErrorOpen Heat Error Over Heat ErrorStop Pressed Stop/Clear has been Wrong ConfigPOP3 Continue or Black OnlyCondition Suggested Solutions Solving Other ProblemsPrinting problems Condition Possible Suggested Solutions CausePrinting quality problems White Spots Toner specksDropouts Vertical linesCopying problems Scanning problems Samsung Scan Manager problemsFax problems Common Windows problemsCommon Linux problems Scanners list Common Macintosh problemsNot appear on Not scanSupplies HOW to PurchaseOrdering supplies Type Average Yielda Part NumberSpecifications General SpecificationsScanner Specifications Printer SpecificationsCopier Specifications Facsimile Specifications Glossary EtherTalk ITU-T No chartEthernet Fuser UnitNetWare MAC addressModem OriginalsUNC Path Subnet MaskToner Cartridge WatermarkClock mode 31 control panel 21 copying IndexReceiving a fax Contact Samsung worldwide Country Customer Care Center WEB SiteSwitzerland Page Features of your new laser product CLX-3175 CLX-3175N Finding More Information Page Safety information6 7Safety information Safety information8 9Safety information Safety information10 11Safety information Safety information12 13Safety information Safety information14 15Safety information Setting up the network CLX-3175N only Installing the software Machines basic settingsScanning Basic Printing Using USB Memory Device Maintenance Troubleshooting CLX-3175N only Scan to StatusStop/Clear 57 to solve the problem Reduce/Enlarge Change Default USB feature Machine Setup Supplied Software Getting started System Requirements Setting UP the Network CLX-3175N only Installing the Software Key sound, and alarm sound Getting started Loading originals and print media Specifications on print media Printer specifications on page 69. The extra flaps Changing the Size of the Paper in the Paper Tray Slide the tray 1 back into the machine Printing on Special Print Materials Copying Press OK when Copy Feature appears Setting Copy Timeout Scanning Changing the Settings for Scan JOB Scanning Basic printing Using USB memory device Printing from a USB Memory Device Managing USB Memory Maintenance Cleaning Your Machine Cleaning the scan unit Maintaining the Cartridge Replacing the Toner Cartridge Replacing the Imaging Unit Replacing the Waste Toner Container Maintenance Parts Clearing paper jams Solving other problems Paper exit area Fuser lever Understanding Display Messages Expires soon Replaceables on 53 and call for Service Solving Other Problems 50. If this does not improve the print White spots appear on AaBbC Scanned face down on the scanner glass Samsung Scan Manager problems Come out Common Macintosh problems Ordering supplies Yieldc.d Waste toner Copying mode Less than 50 dBAContainerc,d Memory Network Scanb File format Effective Glossary FDI LED TCP/IP Adjustment Contact Samsung worldwide Switzerland Page REV Software section Contents Sharing the Printer Locally Using Your Printer in Linux Installing Software for Local Printing Installing Printer SoftwareSelect Typical installation for a local printer. Click Next Custom Installation Select Custom installation. Click NextInstalling Printer Software in Windows Installing Software for Network Printing Custom Installation Installing Printer Software in Windows Reinstalling Printer Software Removing Printer Software Installing mono printer driverClick OK in the Install From Disk window NextPrinting a Document Select your printer driver from the Name drop-down listPrinting to a file PRN Printer SettingsSelect Printers and Faxes Select your printer driver icon Layout Tab Paper TabColor Mode Graphics TabExtras Tab Using a Favorite SettingUsing Help About TabAdvanced Printing Printing Multiple Pages on One Sheet of Paper N-Up PrintingPrinting Posters Printing BookletsFitting Your Document to a Selected Paper Size Printing on Both Sides of PaperPrinting a Reduced or Enlarged Document NoneCreating a Watermark Using WatermarksUsing an Existing Watermark Editing a WatermarkUsing a Page Overlay Using OverlaysWhat is an Overlay? Creating a New Page OverlayCheck the Share this printer box Setting Up a Host ComputerSetting Up a Client Computer Double-clickPrinters and FaxesUninstalling Samsung SmarThru Scanning Using Samsung SmarThruUsing Samsung SmarThru Using Onscreen Help File Windows XP Scanning Process with TWAIN- enabled SoftwareScanning Using the WIA Driver Windows VistaUsing Smart Panel Understanding Smart PanelChanging the Smart Panel Program Settings Opening the Troubleshooting GuideUsing Printer Settings Utility Installing the Unified Linux Driver Installing the Unified Linux DriverGetting Started Uninstalling the Unified Linux Driver Click UninstallOpening the Unified Driver Configurator Using SetIP programUsing the Unified Driver Configurator Starting the programPrinters Configuration Scanners ConfigurationConfiguring Printer Properties Ports ConfigurationPrinting from Applications Printing FilesScanning a Document Click PropertiesUsing the Image Manager Adding Job Type SettingsTools Function Select Easy Install and click Install. Easy Install is Installing SoftwareUninstalling software Select Uninstall and click UninstallClick Add on the Printer List Setting Up the PrinterFor a Network-connected Select Socket/HP Jet Direct in Printer TypeFor a USB-connected Printing Changing Printer SettingsPrinting a Document Printing Multiple Pages on One Sheet of Paper GraphicsScanning with USB Setting scan information in Scan ManagerScanning Scanning with networkIndex Macintosh 37 uninstall