Samsung CLX-3175FW, CLX-3175FN, CLX-3175N, CLX-3170FN manual Samsung Scan Manager problems

Samsung Scan Manager problems

CONDITION	SUGGESTED SOLUTIONS
I cannot use the	Check your operating system. Supporting
Samsung Scan	operating systems are Windows 2000/XP/
Manager.	Vista.

Common Windows problems

CONDITION	SUGGESTED SOLUTIONS
“File in Use”	Exit all software applications. Remove all
message appears	software from the StartUp Group, then restart
during installation.	Windows. Reinstall the printer driver.
“General Protection	Close all other applications, reboot Windows
Fault”, “Exception	and try printing again.
OE”, “Spool32”, or
“Illegal Operation”
messages appear.
“Fail To Print”, “A	These messages may appear during printing.
printer timeout error	Just keep waiting until the machine finishes
occurred.” messages	printing. If the message appears in ready mode
appear.	or after printing has been completed, check the
	connection and/or whether an error has
	occurred.

Refer to the Microsoft Windows documentation that came with your computer for further information on Windows error messages.

Common Linux problems

CONDITION	SUGGESTED SOLUTIONS
The machine does	• Check if the printer driver is installed in your
not print.	system. Open Unified Driver configurator
	and switch to the Printers tab in Printers
	configuration window to look at the list of
	available printers. Make sure that your
	machine is displayed on the list. If not, invoke
	Add new printer wizard to set up your device.
	• Check if the printer is started. Open Printers
	configuration and select your machine on the
	printers list. Look at the description in the
	Selected printer pane. If its status contains
	“(stopped)” string, press the Start button.
	After that normal operation of the printer
	should be restored. The “stopped” status
	might be activated when some problems in
	printing occurred. For instance, this could be
	an attempt to print document when port is
	claimed by a scanning application.
	• Check if the port is not busy. Since functional
	components of MFP (printer and scanner)
	share the same I/O interface (port), the
	situation of simultaneous access of different
	“consumer” application to the same port is
	possible. To avoid possible conflicts, only
	one of them at a time is allowed to gain
	control over the device. The other
	“consumer” will encounter “device busy”
	response. You should open ports
	configuration and select the port assigned to
	your printer. In the Selected port pane you
	can see if the port is occupied by some other
	application. If this is the case, you should
	wait for completion of the current job or
	should press Release port button, if you are
	sure that the present owner is not functioning
	properly.
	• Check if your application has special print
	option such as “-oraw”. If “-oraw” is specified
	in the command line parameter then remove
	it to print properly. For Gimp front-end, select
	“print” -> “Setup printer” and edit command
	line parameter in the command item.
	• The CUPS (Common Unix Printing System)
	version distributed with SuSE Linux 9.2
	(cups-1.1.21) has a problem with ipp
	(Internet Printing Protocol) printing.Use the
	socket printing instead of ipp or install later
	version of CUPS (cups-1.1.22 or higher).
Some color images	This is a known bug in Ghostscript (until GNU
come out all black.	Ghostscript version 7.05) when the base color
	space of the document is indexed color space
	and it is converted through CIE color space.
	Because Postscript uses CIE color space for
	Color Matching System, you should upgrade
	Ghostscript on your system to at least GNU
	Ghostscript version 7.06 or later. You can find
	recent Ghostscript versions at
	www.ghostscript.com.

Troubleshooting_ 64