Pelco TLR3168 operation manual Specifications, Electrical, Video and Audio, Mechanical, General

Page 72

SPECIFICATIONS

ELECTRICAL

 

Power Source:

100-230 VAC ±10%, 50/60 Hz (the included power cord is

 

used for 120 VAC, 60Hz)

Power Consumption:

Approximately 20 watts

VIDEO AND AUDIO

 

Tape Format:

VHS, 1/2-inch width, high-density, video cassette tape

Television System:

EIA standard 525 lines, 60 fields, NTSC-type color system

Video Recording System:

Four rotary heads

Luminance Signal:

Frequency modulation recording

Color Signal:

Low frequency conversion, subcarrier phase shift recording

Audio Track:

One track

Tape Speed and

 

Recording Time:

Refer to Table K

Fast Forward/Rewind Time:

Approx. 120 seconds with T-120 tape

Horizontal Resolution:

More than 400 lines (super resolution mode)

 

More than 240 lines (VHS mode)

Audio Frequency Response:

70 Hz – 7 kHz (6H mode)

Signal-to-Noise Ratio:

Video: better than 42 dB

 

Audio: better than 43 dB

Video Input/Output:

1.0 Vp-p, 75 ohms, BNC plug

Audio Input:

308 mV (rms), 50K ohms, RCA plug

Microphone Input:

0.346 mV (rms), 600 ohms, mini jack

Audio Output:

388 mV (rms), 1K ohms, RCA plug

Battery Backup:

Lasts 31 days

MECHANICAL

 

Heads

 

Video:

Four rotary heads

Audio/Control:

One stationary head

Erase:

One full-track head

Motors:

Three direct drive (drum/capstan)

Connectors

 

ALM Input:

Screw terminal for starting alarm recording

RST Input:

Screw terminal for finishing alarm recording or for adjusting

 

on-screen clock

REC Input:

Screw terminal for starting/finishing recording or for series

 

recording

GND:

Screw terminal for ground

ALM Output:

Screw terminal for output while alarm recording is underway

CLK Output:

Screw terminal to command camera switching

MODE Output:

Screw terminal for indicating the VCR’s selected mode

CALL Output:

Screw terminal for external warning device or for series

 

recording

REMOTE Jack:

Jack for connecting the remote control circuit

RS-232C Interface:

DB9

GENERAL

 

Operating Temperature:

41° to 104°F (5° to 40°C)

Relative Humidity:

Maximum 80%

Dimensions

 

(JOG Dial Included):

16.7 (W) x 12.4 (D) x 3.7 (H) inches (42.5 x 31.4 x 9.5 cm)

Weight:

9.7 lb (4.4 kg)

Weight and dimensions show are approximate.

(Design and product specifications subject to change without notice.)

72

Pelco Manual C673M (2/01)

Image 72
Contents TLR3168 Time-Lapse VCR Installation C673M 2/01 Contents Pelco Manual C673M 2/01 List of Illustrations List of TablesGeneral AvertissementSAFEGUARDS, WARNINGS, CAUTIONS, and Care Cleaning AccessoriesLightning/Power Surges When Not In UseUnpacking Instructions Introduction to TIME-LAPSE RecordersTLR3168 Features and Functions Quick Start Basic StartAdditional Items Installation PRE-INSTALLATION CautionsSecuring the VCR Controls Monitor TipsInstallation Typical System SetupConnecting the VCR to a Multiplexer Connecting a VCR to a MultiplexerAlarm Recording Connection Connecting for Series RecordingConnecting for Remote Recording Connecting for Synchronous Recording Connecting for External Time Clock AdjustmentConnecting the VCR to a PC Connecting to a PC for Remote ControlTable A. RS-232C Protocol Cable Connections Controls Front PanelPLAY/REC Check POSITION/VERTICAL Adjust buttons + Timer REC buttonEject button Search buttonFluorescent Display Timer Recording indicator Tape Remaining indicatorEmgcy emergency recording indicator LOCK/LOCK a indicatorMode OUT Rear PanelCall OUT Adjusting the Clock and Using the JOG and Shuttle Controls Using the JOG DialUsing the Shuttle Ring JOG and Shuttle ControlsAdjusting the Clock Adjusting to the Exact SecondProgramming General Programming InstructionsLanguage Selection Menu MenuProgram to Record Holiday SET UP Quick Guide to the Menu StructureDisplay Menu Display Mode Main MenuTIME/DATE Size Blue BackTimer Program START/ENDRecording SET UP Menu Setting Rear Terminal MenuWrngtape END Wrngremain Tape END Clock OUTREC Maintenance Menu First Time SET UP MenuRS-232C Menu Additional Material DAY and Time Display ModesSET the DAY and Time Main Menu DisplayLOADING, UNLOADING, Protecting the Tape Cassette LoadingWhen to Replace a Tape Table C. Tape Replacement by UseUnloading Preventing Accidental ErasureRecording Manual RecordingRecording Mode Recording Check FunctionAudio RECORDING/PLAYBACK Repeat RecordingTable E. Action When Tape End Is Reached by Setting Stop Rewind Repeat AlarmprotSeries Recording Remote Recording ONE-SHOT/INTERVAL RecordingSynchronous Recording Synchronous Recording SequenceTimer Recording Programming ProcedureHoliday SET UP Special DW SettingWhat if the Timer Recording Indicator Starts FLASHING? Overlapping ProgramsAlarm Recording Table G. Minimum Interval Between RecordingsProgramming for Alarm Recording Maintenance Recording After a Power FailurePower Loss List Viewing the Power Loss ListAlarm List Viewing the Alarm ListClearing the Alarm List ALL Menu Initialize ResetElapsed Time and Repeat Recording Times Display Elapsed TimeRepeat REC Times Playback Procedure PlaybackPlayback Mode Audio PlaybackEND of Tape Special Effects PlaybackShuttle Ring Direct Shuttle RingAdjusting the Picture During Playback Tracking Adjustment Adjusting Picture QualityVertical Vibration Adjustment Search Techniques Counter Memory StopSkip Search HOW to Count the Index Number Index SearchTime and Date Search Additional Functions and Features Using with a PC Assigning the RS-S32C SettingsCommands from a PC When Controlling only ONE VCRSending Commands Status or Error Code from Meaning When Controlling Multiple Vcrs Commands When Controlling Multiple VCRsVCR01, RC CR Commands and Responses Chart Commands Functions Status After Normal Explanation of StatusOn next SKP Small =WRNG, 1=WRNGTAPE END =OFF, 1=ON Testing Error CodesInitial System Testing Regular System TestingTroubleshooting SELF-DIAGNOSTIC Function and Warning DisplayTable J. Warning Display and Actions Fluorescent Monitor Cause Remedy To Turn Off DisplayBefore Calling for Service Symptom RemedyRecording Problems Specifications ElectricalVideo and Audio MechanicalVideo Audio Tape Mode 120/T-160 Mm/s Field Fields/s Table K. Tape Speed and Recording TimeIndex Pelco Manual C673M 2/01 Regulatory Notices Revision History