Setting Up Your VCR
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you have completed the automatic channel memorizing by using ALLSET. You cannot do this for chan- nels coming from a satellite receiver.
1Make sure that video mute is ON. See page 60.
2Set the VCRÕs input to tuner. To do this, press INPUT on the remote control until a channel number appears on the screen or the front panel display.
3Press MENU on the remote control. VCR Main Menu appears.
4Turn the ADJUST dial on the remote control to select First Time
5You will see the First Time
IMPORTANT
If you are recording, playing back a tape, receiving a video signal from an external input, or watching a satellite receiver channel, then Not available will flash
6You will see the screen for adding or deleting channels. Use the ADJUST dial to select the channel that you want to add or delete. Press ENTER or turn the SHUTTLE ring to the right to add the channel; press CANCEL or turn the SHUTTLE ring to the left to delete it.
7When you are finished adding or deleting channels, press MENU three times to exit the menus.
IMPORTANT
If you use ALLSET to memorize channels again, you will lose all of the manual changes you made. All of the channels you deleted will be added; all of the channels you added will be deleted. If your cable box receives only one or two digit channels, you cannot add a
ÄFirst Time
ÅSet the clock ÇAdd/delete channels
±Sat.receiver (OFF)
¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹ Use ADJUST to select, and ENTER.
Press MENU to go back.
ÇAdd/delete channels
Channel 39
Not in memory
Use ADJUST to select a channel. Use ENTER to add it, CANCEL to delete it.
Press MENU to go back.
21