Timer Recording
Cancelling a Timer Recording before the Recording Starts
1Press MENU on the remote control. Your VCR will turn on and VCR Main Menu will appear on your screen. Turn the ADJUST dial on the remote control to select Program to record. Turn the SHUTTLE ring to the right.
2Recap screen will display for 4 seconds. While this screen is displayed, turn the ADJUST dial to place the cursor next to the program you wish to cancel.
3Press CANCEL. The program is erased.
4Press MENU twice to turn off the menus.
Using a Satellite Receiver
If you are using a Mitsubishi, Panasonic, RCA, Sony, Toshiba, or Hughes satellite receiver, your VCR will automatically turn the receiver on when a timer recording begins and off when the recording ends.
However, if you are using a PRIMESTAR¨ or DISH Networkª receiver, you will have to turn the receiver on before a timer recording begins.
Before turning off the VCR, to put your VCR in
You can watch satellite channels through your VCR even when the VCR is turned off but only if you connected your VCR and TV with an
Recap screen
ÂProgram to record
CH DAY | ON | OFF |
¤2 MO12 11:30a 1:30pSP
---
---
---
¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹ Use ADJUST to select, and ENTER.
Press MENU to go back.
TIMER RESET
You can use TIMER RESET on the rear panel to erase both the clock and all timer VCR Rear Panel recordings.
To use TIMER RESET, press it with a pencil or a ball point pen. The power will turn off and the clock will be cleared. All timer recordings are erased.
TIMER RESET 
If you have set the Clock set setting of the Set the clock menu to AUTO, the auto
TIMER RESET
clock function will automatically set the clock again.
Memory Backup
If the VCR is without power for 30 minutes or less, it will retain the clock and the programmed settings. The VCR must have been plugged in for at least an hour beforehand to charge this backup. If the power is lost for more than 30 minutes, the time and the programmed settings will be lost.
If you have set the Clock set setting of the Set the clock menu to AUTO, the auto clock function will automatically set the clock again when power is restored.
50