Sennheiser RS2400 Putting the Receiver Into Operation, Switching on the Receiver

PUTTING THE RECEIVER INTO OPERATION

Charge the accupack for 24 hours before you use it for the first time!

￿ Take your stethoset receiver out of the charging compartment on the transmitter.

￿Have you charged the accupack separately from the stethoset receiver?

Then insert the accupack into compartment in the receiver.

SWITCHING ON THE RECEIVER

Use control to switch on the receiver and adjust the volume.

ADJUSTING THE RECEIVER CHANNEL

Transmitter and receiver have to operate on the same frequency:

￿Put the transmitter and the receiver into operation as described above. Switch on the TV set! If possible, switch off its loudspeakers.

￿	Use switch on the transmitter to select a
	transmission channel.
￿	Set the volume control	on the receiver to a
	medium value (position 3–4).
￿	Slowly turn control	(“TUNE”) on the

stethoset receiver until you can hear the audio signal loud and clear. The receiver’s AFC (Automatic Frequency Control) circuitry stabilises your adjustment.

Transmitter and receiver are now operating on the same frequency.

18