Panasonic TC-P55VT30, TC-P65VT30 owner manual Disposal, How to remove the battery

Page 62

Disposal

3D Eyewear

A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations. When disposing this product, disassemble properly by following the procedure below, and remove the internal rechargeable battery.

Do not disassemble this product except when disposing of it.

Danger

As the rechargeable battery is specifically for this product, do not use it for any other device.

Do not charge the removed battery.

Do not throw the battery in a fire, or apply heat to it.

Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.

Do not let the wires touch any other metal or each other.

Do not carry or store the battery with a necklace, hair pin, or the like.

Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun. Doing so may cause the battery to generate heat, ignite, or rupture.

Warning

Do not place the removed battery, screws, and other items within reach of infants. Accidental swallowing of such an item may have an adverse effect on the body.

In the event that you think such an item has been swallowed, consult a doctor immediately.

In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with bare hands.

Fluid entering into an eye may cause loss of eyesight.

Wash the eye with water immediately without rubbing it, and then consult a doctor.

Fluid getting on your body or clothes may cause inflammation of the skin or injury.

• Sufficiently rinse with clean water, and then consult a doctor.

How to remove the battery

Disassemble this product after the battery has run out of power.

The following figures are intended to explain how to dispose of the product, not for describing how to repair. The product cannot be repaired once it has been disassembled.

1.

Fold the part of the

 

 

frame without the power

Screws

 

switch, and then remove

 

the two screws on the

 

 

inside of the hinge with a

 

 

precision Phillips (plus + )

Frame

 

screwdriver.

2. Bend the frame inwards

Side cover

 

and pull it off from the side

 

 

cover.

 

• If it is difficult to remove,

 

 

insert a flat-blade (minus - )

 

 

screwdriver and force it off.

 

Battery

3. Remove the battery from inside the side cover, and cut the two wires one by one with scissors.

• Insulate the wire parts of the removed battery with cellophane tape.

Note

Take sufficient care when performing this work so as not to injure yourself.

Do not damage or dismantle the battery.

62

Image 62
Contents 55,1/64,7 pulgadas medidas diagonalmente English Español55.1/64.7 inches measured diagonally VieraTypical still images Set upDo not display a still picture for a long time Contents Safety Precautions Important Safety InstructionsWhen Moving the Plasma TV AC Power Supply CordHandling the power supply cord To prevent fire or electric shockAbout 3D Eyewear About Prohibition of DisassemblyHeating About Prevention of Accidental IngestionFCC Statement Accessories AccessoriesOptional Accessories Attaching the pedestal to TV Getting started Accessories/Optional AccessoriesAssembly screws Removing the pedestal from the TVInstalling the remote’s batteries Do not disassemble or modify the pedestalConnections Connections Accessories/OptionalAccessories Connection PanelsAV cable connection Video adapter whiteRS232C connection Audio connectionPC / Computer connection VGA Cable Binding InstructionsSwitches TV On or Off Standby Displays 3D settings. p TV controls/indicatorsRemote control Identifying ControlsConfigure your viewing mode First Time SetupTurn the TV On with the Power button Identifying ControlsLabel the inputs for easy identification Label inputs ANT/Cable setupSelect signal type Cable/Antenna Select scan typeSetup Configure Network settingsAdjust the Clock Set clock Started First TimeWireless network First time setup Complete First time setupAbout wireless LAN WPS Wi-Fi Protected SetupSelect a channel number Turn power onWatching TV Call up a favorite channel Change aspect ratio and Zoom the pictureDisplay the SUB Menu Operate USB keyboard Password setting/enteringEntering characters Watching TVUsing Viera Tools Select the item Set each itemExternal devices Display the Input select menu Select the input modePress Game to switch to the game screen Viewing 3D images on TV Charging the 3D Eyewear Viewing 3D images on TVAttaching Ferrite Core 3D Eyewear 3D Eyewear caseView Using PrecautionsWearing the 3D Eyewear After Use3D images on TV 3D settings Adjust 3D imagesChange the view 3D⇔2D Media information Using Media playerBasic features for Media player Display Media player Select Drive Using MediaInsert Media SD card or USB flash memory Select the data Photos/Videos/MusicSlideshow Slideshow settingsSoundtrack settings Photos viewPhoto options Using Media playerSort Videos view Select Video options in Setup SUB MenuVideo options Repeat playbackMusic options UsingOther settings in Media player Media playerHdmi cable Viera LinkTM Hdavi ControlTMVersion Equipment onlyViera LinkTM Hdavi ControlTM Viera Link Connections with Viera Link functionViera Link settings and Available features Display the menu Select Viera Link settings in SetupSelect and make other settings Select Viera LinkPower off link Automatic Input SwitchingPower on link Energy saving modeSelect Viera Link menu and Available featuresDisplay the Viera Link menu Select the item Press to go back to the previous ScreenSetBack to TV Viera Link control only with the TV’s remote controlSpeaker control Dlna remote control Using Network servicesUsing Dlna feature Home network p Using Network camera pConnecting to the Internet Contact your Broadband service providerSelect wired or wireless connection Using Network servicesWireless network Confirm Current settings and status Display the menu Select Network settingsSelect the settings and set Connection testProxy setting Wireless network Wireless network settingIP address/DNS settings Select Viera network name Select Software updateEdit the name of this TV Edit the name and press OKViera Connect Enjoy Internet Service ServicesOther settings Display the Home screenSelect server Select contentsDisplay Viera Tools Select the Dlna View/PlayNetwork Camera Viera Link control only with the TV’s remote control pDefault camera setting p Display Viera Link menuSelect ANT/Cable setup Editing and Setting ChannelsDisplay the menu Select Setup ANT/Cable setup and operationManual program Set manually Setting ChannelsSignal meter Check signal strength Display the menu How to Use Menu FunctionsSelect the item and adjust Select the menuHow to Use Menu Functions Adjustments PC adjustments Settings ItemsAdjustments Hdmi settingsAudio settings Adjust Audio quality Program Mode Settings Items Item Description Mode OffChannel Mode Mode On/OffSetup Other function settings Ratings List for parental control Movie Ratings MpaaSize Technical InformationAspect Ratio Format Aspect Ratio2D→3D Simulated 3D Data format informationSD Card/USB flash memory warning messages Hdmi connection Technical Information Support InformationViera LinkTM Hdavi ControlTM Digital Audio OUT terminalPC Input Terminals Input signal that can be displayedSide bars Cabinet Care and CleaningDisplay panel PedestalDisposal How to remove the batteryDo not disassemble this product except when disposing of it Frequently Asked QuestionsDisposalFAQ Support Information Questions AnswersNetworking Why is the sound unusualDistorted, low volume or QuestionsFrequently Asked Questions FAQ Support Information NetworkingSpecifications FeaturesSpecifications Support Information Page Index Index Support InformationLimited Warranty for U.S.A. and Puerto Rico only For hearing or speech impaired TTY users, TTY Customer Services Directory United States and Puerto RicoAccessory Purchases United States and Puerto Rico Limited Warranty for Canada Panasonic Product Limited WarrantyLimited Warranty for Canada Support InformationAmbler Drive Customer’s RecordAnotación del cliente