Pelco DX3009-060, DX3016-060, DX3016-120 manual Schematics for Alarm Input and Output Terminals

POWER ON/POWER OFF/￿				ALARM OUT/MODE OUT Output terminal ￿
ALARM IN/REC/CLOCK ADJ￿
Input terminal ￿		5V		• Output Circuit
• Input Circuit
	10kΩ￿		5V
Input￿	22kΩ￿			Output terminal
terminal
	0.047µF￿			GND terminal
GND	￿
				<Interface circuit inside the unit>
<Interface circuit inside the unit>

Figure 7. Schematics for Alarm Input and Output Terminals

3.Optional. Connect the recorder to a remote source for turning the unit on/off.

By using the POWER ON/POWER OFF terminals, it is possible to turn on/off the recorder externally. The POWER ON terminal turns power on or off (refer to Figure 8). The POWER OFF terminal turns power off (refer to Figure 8). Turning the recorder on/off also controls the output of the DC 5V OUT terminal (refer to Figure 8). Figure 9 shows the schematic for the POWER ON/POWER OFF terminals.

Using POWER ON terminal

POWER ON
terminal		ground
Unit's
power	power on	power off
	shut down
DC 5V OUT
(4.5-5.5V	DC 5V	0V
Max.30mA)

boot power on up

Using POWER OFF terminal

POWER OFF		ground
terminal
Unit's
power	power on	power off
	shut down
DC 5V OUT
(4.5-5.5V	DC 5V	0V
Max.30mA)

Figure 8. Operation of Power On and Power Off Terminals

POWER ON/POWER OFF/￿ ALARM IN/REC/CLOCK ADJ￿

Input terminal ￿ 5V

• Input Circuit

10kΩ￿ 5V

Input￿ 22kΩ￿ terminal

0.047µF￿

￿

GND

<Interface circuit inside the unit>

Figure 9. Schematic for Power On and Power Off Terminals

4.Optional. Connect equipment to the CLOCK ADJ, REC, MODE OUT, and CALL OUT terminals. Refer to Figure 10 for schematics of the input/output terminals.

The CLOCK ADJ input terminal is used for adjusting the clock. The input is active when a ground or low voltage signal is applied. The input is non-active when the termi- nal is open.

Pelco Manual C681M-D (2/02) 13