5.Do one of the following:
•Turn the JOG dial to go to another item in this menu.
•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to another menu.
•Press the SET UP button to exit the programming mode.
INITIALIZE MENUS
Initializing the menus returns most settings to their default values.
Skip steps 1 and 2 if they have already been done.
1.Press the SET UP button to display the Menu Setting menu.
2.Turn the JOG dial to move the cursor to SERVICE, and then turn the SHUTTLE ring to the right. The Service menu appears.
3.Turn the JOG dial until the cursor is next to MENU INITIALIZE, and then turn the SHUTTLE ring to the right. The option starts flashing.
NOTE: If the PRE
4.Turn the JOG dial to select ON or OFF.
5.If you selected ON, “PUSH WARNING RESET KEY THEN ALL MENU WILL BE INI- TIALIZED.” appears on the screen. Press the WARNING RESET button. The
If you selected OFF, turn the SHUTTLE ring to the right. The option stops flashing.
6.Do one of the following:
•Turn the JOG dial to go to another item in this menu.
•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an- other menu.
•Press the SET UP button to exit the programming mode.
MODE OUT
With this setting, a signal can be output to indicate the status of the recorder.
Skip steps 1 and 2 if they have already been done.
1.Press the SET UP button to display the Menu Setting menu.
2.Turn the JOG dial to move the cursor to REAR TERMINAL, and then turn the SHUTTLE ring to the right. The Rear Terminal menu appears.
3.Check that the cursor is next to MODE OUT, and then turn the SHUTTLE ring to the right. The option starts flashing.
Pelco Manual | 35 |