Sterling 882.00249.00 manual Controller Keypad, Key Descriptions, Label Description

Controller Keypad

Your 12-station controller has a 16-position keypad to let you operate and alter controller parameters. With the exception of the SET key, each key has at least two functions. The status of the controller determines what function is recognized.

Figure 4: Controller Keypad

1	2	3
ST 1	ST 2	ST 3
4	5	6
ST 4	ST 5	ST 6
7	8	9
ST 7	ST 8	ST 9
NO	0	YES
ST 10	ST 11	ST 12

Key Descriptions

START STOP

SET

CLEAR PRIOR ENTER

MENU

Label	Description
Number	Use the ten (10) numeric keys marked 1 to 0 to enter numerical information
Keys	on the controller.
Station Keys	Press one of the 12 station keys marked ST1 to ST12 to select or activate the
	specific station or hopper you want.
Start/Stop	Press the START/STOP key once to start the loading sequence. Press the
Key	START/STOP key again to stop the loading sequence.
Set Key	Press the SET key to set hopper loading times. Using the SET key also
	permits you to increment through each of the twelve (12) stations/hoppers
	when setting loading times. Press the SET key to save the updated value of
	the parameter you set, then increments to the next station.
Clear/Prior	Press the CLEAR/PRIOR key to initiate the priority convey sequence; this
Key	key also acts much like an escape key.
No/Yes	Press the NO or YES keys to answer questions or prompts while you are
Keys	using the menu system.
Enter/Menu	Press the ENTER/MENU key to save any data you entered in the controller
Key	memory. You can also press the key to let you enter the menu system.

2–Pump 12-Station Controllers Chapter 4: Operation 39