Sanyo VCC-6974 instruction manual Connections, Basic connection for monitoring or recording

CONNECTIONS

Basic connection for monitoring or recording

(Video signal connections)

: VIDEO IN	(A)
: VIDEO OUT

AC 24 V connection
GND	AC24V
Fig. 1

DC 12 V connection

GND
DC12V
+
DC12V
+	–
–

Fig. 2

The peripheral devices (VCR, monitor, lens, etc.) and cables are sold separately.

1Make the video signal connection between the camera and the monitor or timelapse VCR.

2Power supply choices

•When using an AC 24 V power supply (UL listed class 2 power supply), make the connections as indicated in Fig. 1.

•When using a DC 12 V power supply, make the connections as indicated in Fig. 2.

CAUTION:

•To prevent camera and/or power supply failure, pay close attention to polarity when making the connections.

•To prevent fire hazard any UL listed wire rated VW-1, should be used for the 24 V AC cable input terminal.

3Insert the plug of this power supply into a wall outlet. The POWER indicator (A) will light. Adjust the picture on the monitor using the Brightness and Contrast controls.

Coaxial cable type and maximum length

•Cable type RG-59U (3C-2V), 250 m maximum.

•Cable type RG-6U (5C-2V), 500 m maximum.

•Cable type RG-11U (7C-2V), 600 m maximum.

CAUTION:

•The RG-59U type cable should not be run through electrical conduits or through the air.

•Use CCTV/Video-grade coaxial cable.

10 English