Sanyo VCC-6974 instruction manual Active

USING THE MENU SCREEN MOTION/EXAMPLE

DIRECTION setting

Select the desired direction arrows (ex.: íí). The detection will be done when the subject moves in the direction of the arrows. For example, the setting can be done in order to detect a subject entering a room, but ignored when it is going out of the room.

SIZE setting

From the SIZE SET item switch to the MOTION SIZE screen. This setting allows you to set the area covered before detection is done.

The default setting is 2 squares (1 horizontally, 2 vertically). Each square corresponds to 1/64 of the screen area (there are 64 (8 x 8) squares on the screen). The default setting will detect a movement that is sensed in 2 squares simultaneously.

Note:

•If set to 1 square, the detection rate will be the highest, any slight movement being detected.

•If set to 2 squares or more, movement must be detected simultaneously in all the squares, the detection rate will therefore be lower.

MASKING setting

Switch from the MASKING screen to the MOTION MASKING screen. In this screen, using a black mask, you can mask movements of subjects (like the swaying of a tree, or light flickering on the monitor screen) that should not be detected.

DIRECTION

Active

MOTION SIZE

V2

H 1

MOTION SIZE

V2 H 2

Active

English 47