Sanyo VCC-6974 Sensitivity setting, This sets the movement amplitude of subjects on the screen

USING THE MENU SCREEN MOTION/SENSITIVITY

DSENSITIVITY setting

The smaller the setting value, the greater the sensitivity.

Press the CURSOR (l) button to select the SENSITIVITY setting “SET” (the setting will flash), then press the SET button.

The SENSITIVITY screen will be displayed.

MOVE

This sets the movement amplitude of subjects on the screen.

Press the CURSOR (d or c) button so that the MOVE value is flashing. (Maximum: 6)

Set the value to a large to avoid detecting slight movement such as movement caused by the wind.

Y-LEVEL

This sets the brightness level. Any signal darker that the set brightness will be ignored. This is mainly used to avoid incorrect detection caused by electronic noise in a dark picture.

Press the CURSOR (l, then d or c) button so that the Y-LEVELvalue is flashing. (Maximum: 10)

Set the value to a large to avoid incorrect detection of movement caused by electronic noise from a dark picture.

Y-DIFFER

This sets the brightness change level. A lower setting will ignore bigger changes in the brightness.

Press the CURSOR (l, then d or c) button so that the Y-DIFFERvalue is flashing.

(Maximum: 10)

This allows movement to be detected when there are variations in brightness. Set the value to a large if lights being turned on and off are not to be detected.

CURSOR SET

CURSOR SET

ADJUSTMENT FOR MOTION

DIRECTION		OFF
SIZE		SET	p
MASKING		ON	p
SENSITIVITY		SET	p
SENSITIVITY
MOVE	í---ú	----ü	3
Y-LEVEL	í-ú------	ü	3
Y-DIFFER	í------	ú-ü	8
DURATION	ú--------	ü	1

English 43