System Menu, Analog OUT, Sync Master

SYSTEM Menu


<SYSTEM>
>IR-RECEIVE				ON
IMG-FLIP				OFF
PAN	REVERSE			OFF
TILT	REVERSE			OFF
DISPLAY		INFO		OFF
ANALOG		OUT	YPBPR
SYNC	TYPE			SYNC
SYNC	MASTER			STD

IR-RECEIVE (infrared signal reception)

When it is set to OFF, the camera does not receive the signal from the supplied Remote Commander.

Be sure to keep it ON when you use the supplied Remote Commander.

Note

You cannot set IR-RECEIVE to OFF when you operate the menu using the supplied Remote Commander. To set it to OFF, use the RM-BR300 Remote Control Unit (not supplied) or the VISCA command.

IMG-FLIP (image flip)

Set IMG-FLIP to ON to rotate the camera image supplied from the RGB/COMPONENT connector upside down and to reverse the direction of the camera movement by pan/tilt operation.

Set PAN REVERSE to ON to reverse the horizontal movement of the camera image.

Set TILT REVERSE to ON to reverse the vertical movement of the camera image.

When you set IMG-FLIP to ON, “Please restart system!” appears. Turn off the power of the camera and turn it on again.

Note

•Regardless of the IMG-FLIP ON/OFF setting, images shot by the camera are accumulated for the vertical synchronization period and output from the RGB/ COMPONENT connector of the camera and the connector on the optional interface board inserted into the card slot.

•When you set IMG-FLIP to ON, then turn off the camera and turn it on again, PAN REVERSE and TILT REVERSE will be set to ON. When you set IMG-FLIP to OFF, then turn the power off and on again, PAN REVERSE and TILT REVERSE will be set to OFF.

DISPLAY INFO (information display)

When the camera settings are stored in POSITION 1 to 16 using the supplied Remote Commander or the RM- BR300 Remote Control Unit, the message “PRESET No. xx” automatically appears for 2 seconds on the monitor screen. If you want to display the message each time the camera is operated, set DISPLAY INFO to ON. Set it to OFF to cancel the display.

Note

The message will appear if the built-in cooling fan of the camera has accidentally stopped. When DISPLAY INFO is set to OFF, the display of this message is also canceled.

ANALOG OUT

Select the signal output from the RGB/COMPONENT connector on the camera. Select YPbPr for component signal output, or RGB for RGB signal output.

When RGB is selected with ANALOG OUT, ADD SYNC appears. If you set ADD SYNC to RGB, a sync signal is added to each R, G and B signal. If you set it to OFF, no sync signal is added.

SYNC TYPE appears when either YPbPr or RGB is selected with ANALOG OUT, and you can select the type of sync signal, SYNC for tri-level sync or VD for bi-level sync.

SYNC MASTER

When you connect a sync signal generator, you can select an output video signal that is synchronized with the external video sync signal input to the EXT SYNC IN connector on the camera from the generator.

STD: The output video signal from the RGB/ COMPONENT connector on the camera is synchronized with the external video sync signal.

HD1: The output signal from the HFBK-HD1 HD Interface Board inserted into the camera is synchronized with the external sync signal.

SD1: The output signal from the HFBK-SD1 SD Interface Board inserted into the camera is synchronized with the external sync signal.

Note

This menu item is available when the HFBK-HD1 or HFBK-SD1 Interface Board is inserted into the BRU- H700 HD Optical Multiplex Unit.

Adjusting and Setting With Menus

SYSTEM Menu