Sony HD 3CCD operating instructions Zooming, Operating Multiple Cameras with the Remote Commander

Arrow button Movement of the	Setting
camera
	L/R
	DIRECTION SET
	While holding down
	STD
	1
	Press.
	L/R
	DIRECTION SET
	While holding down

Zooming

Press either of the ZOOM buttons.

PAN-TILT

RESET

SLOW ZOOM FAST

Subject appears	T	T
	W	W
farther away.
(Wide angle)	L/R
	DIRECTION SET
		RM-EV100
Zooms in or out
slowly
(SLOW side)

Subject appears closer. (Telephoto)

Zooms in or out fast (FAST side)

Operation Using the Supplied Remote Commander

REV

2

Press.

Note

The setting above only changes the signal emitted from the Remote Commander, and does not change the setting of the camera itself. Therefore, repeat the setting for each Remote Commander if you are using more than one Remote Commander.

If the STANDBY lamp of the camera flashes

When the camera is moved or turned by hand or by external shock, the microcomputer inside the camera may not be able to memorize the pan/tilt position properly and the camera may stop.

To reset the pan/tilt position, press the PAN-TILT RESET button or turn the power of the camera off and turn it on again.

STANDBY flashes.

Note

When you perform pan/tilt operation while the camera is in the telephoto mode, the moving speed of the image on the screen may be a little jerky.

Operating Multiple Cameras with the Remote Commander

1 Set the IR SELECT switch on the rear of the camera you want to operate to 1, 2 or 3.

1 2 3

IR SELECT

2 Press the CAMERA SELECT button on the Remote Commander that corresponds to the number set in step 1.

		POWER
CAMERA SELECT			CAMERA
1	2	3
FOCUS			SELECT
AUTO		MANUAL
FAR	NEAR
DATA SCREEN		BACK LIGHT

Then, you can operate the camera(s) specified by number. Every time you operate the camera(s) using the Remote Commander, the CAMERA SELECT button pressed in step 2 lights.

40

Pan/Tilt and Zoom Operation