2 Insert an optional interface board into the card slot. Align both ends of the interface board with the sliders inside the slot, then insert the board securely as far as it will go.
Interface board (not supplied)
3 Tighten the two screws on the interface board.
To remove the interface board
Loosen the two screws on the interface board and pull the board out straight and slowly.
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
If you have to place the camera on an inclined surface, make sure that the inclination is less than ±15 degrees, so that the pan/tilt performance is guaranteed, and take
an appropriate countermeasure to prevent the camera from falling.
Notes
•Do not grasp the camera head when carrying the camera.
•Do not turn the camera head by hand. Doing so may result in the camera malfunctioning.
Installation and Connections
To attach the camera to a tripod
Attach a tripod to the screw hole used for attaching a tripod on the bottom of the camera.
The tripod must be set up on a flat surface and tightened firmly by hand.
Use a tripod with screws of the following specifications.
1/4
= 4.5 mm – 7 mm 
= 0.18 – 0.27 inches
Installation
51