Operation Using the RM-BR300 Remote Control Unit
Before operating, check that the camera, the
For details, see “Installation” (page 50) and “Connections” (page 54).
To turn on/off the camera using the RM- BR300 Remote Control Unit
As long as the camera is connected to an AC outlet, you can turn the camera on or off with the POWER button on the Remote Control Unit.
While holding down the POWER button, press the CAMERA button corresponding to the camera whose power you want to turn on/off.
When you turn the power off using the Remote Control Unit, the POWER lamp turns off and the STANDBY lamp lights on the camera.
Turning on the Power
1 |
| 2 RESET |
| PANEL LIGHT | |||||||
VALUE | LOCK |
|
| PANEL | BLACK | ONE PUSH |
|
| |||
|
|
|
|
| LIGHT | LIGHT | RESET |
| AWB |
| MENU |
|
|
| RESET |
|
|
|
|
|
|
|
|
– | + |
|
|
|
|
|
|
|
|
|
|
| R |
| PRESET |
|
| POSITION |
|
|
|
| |
|
| MODE |
|
|
|
|
|
| |||
BRIGHT |
|
|
|
|
|
|
|
|
|
| |
|
|
| SHIFT | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
| 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 |
– | + |
| L/R | STD | REV |
|
|
|
|
|
|
| B |
| DIRECTION |
|
| CAMERA |
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
|
| AUTO |
|
|
|
|
|
|
|
|
|
FOCUS | AUTO | POWER | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
| |
|
| MANUAL |
| ||||||||
|
| ONE PUSH |
|
|
|
|
|
|
|
|
|
NEAR | FAR | AF |
|
|
|
|
|
|
|
|
|
POWER CAMERA
STANDBY lights.
To illuminate the panel of the Remote Control Unit
Press the PANEL LIGHT button. All the POSITION buttons and CAMERA buttons light.
To turn off the illumination, press the PANEL LIGHT button again.
PANEL
LIGHT
Operation Using the
1 Connect the camera to an AC outlet using the supplied AC power adaptor and power cord. The power is turned on and the POWER lamp lights.
The camera will automatically pan and tilt and be reset to the position stored in POSITION 1 (Pan/tilt reset action).
2 Press the ON/OFF switch on the
The CAMERA button representing the camera whose power was turned off last lights. (The CAMERA 1 button lights by default.)
3 Turn on the peripheral devices.
Note
Be sure to turn on the power of the camera before the power of the Remote Control Unit. Otherwise, the Remote Control Unit cannot recognize the connected camera.
Operating Multiple Cameras
Before operating, you must assign the camera addresses to the connected cameras as follows. Then you can switch the camera to be controlled simply by pressing the corresponding CAMERA button.
To assign camera addresses automatically
1 Make sure that the camera address selector on the bottom of each camera is set to “0.”
For setting the camera address selector, see page 19.
2 Turn on the power of all the connected cameras and the
Remote Control Unit
Turning on the Power
43