JVC GV-DS2 manual Initializing Jlip, Select Transfer Rate. Normally select

20EN

INITIALIZATION

INITIALIZING JLIP

The first time you start the Video Capture software, JLIP initialization is required. This sets which of the computer’s COM ports (connector into which the RS-232C cable is plugged) is connected to the JLIP Video Capture Docking Station. The initialization window automatically appears the first time you start the software after installation. Do not forget to carry out this JLIP initialization procedure. The JLIP must be initialized again whenever you connect a new image source or other unit to the JLIP Video Capture Docking Station.

1.

2.

3.

4.

5.

Start the JLIP Video Capture software.

The "JLIP Initialization" screen automatically appears.

Select "COM Port".

•COM1 through COM4 ports are available. Check to see which COM port is connected to the JLIP Video Capture Docking Station and select it.

Select "Transfer Rate". •Normally select 38400.

•38400 may not be available on some computers. When transmission errors take place during use, switch to 19200 or 9600. Image data transmission will be slower at these speeds.

Click "OK" . Call up the "JLIP Initialization" window and check the connected units.

JLIP Initialization
COM Port	COM 1

Transfer Rate 38400

OK

Cancel

NOTE : If you want to change a unit or COM port or Transfer Rate, select "Initialize" from "Set-up" in the menu bar to call up the "JLIP Initialization" window. Repeat this setting procedure.

If a connection is incorrect, a connected unit is not turned on, or the connection ID numbers overlap, the message "Connection error" appears. Click "OK" to return to the Main desktop.