Pelco cs73m-d Setting UP a Unit AS the Master Clock, Resetting to Factory Defaults

Table B. Address Switch Settings (Continued)

		SWITCH SETTINGS
ID	1	2	3	4	5	6	CAMERA RANGE SELECTED
41	OFF	OFF	OFF	ON	OFF	ON	Cameras 641-656
42	ON	OFF	OFF	ON	OFF	ON	Cameras 657-672
43	OFF	ON	OFF	ON	OFF	ON	Cameras 673-688
44	ON	ON	OFF	ON	OFF	ON	Cameras 689-704
45	OFF	OFF	ON	ON	OFF	ON	Cameras 705-720
46	ON	OFF	ON	ON	OFF	ON	Cameras 721-736
47	OFF	ON	ON	ON	OFF	ON	Cameras 737-752
48	ON	ON	ON	ON	OFF	ON	Cameras 753-768
49	OFF	OFF	OFF	OFF	ON	ON	Cameras 769-784
50	ON	OFF	OFF	OFF	ON	ON	Cameras 785-800
51	OFF	ON	OFF	OFF	ON	ON	Cameras 801-816
52	ON	ON	OFF	OFF	ON	ON	Cameras 817-832
53	OFF	OFF	ON	OFF	ON	ON	Cameras 833-848
54	ON	OFF	ON	OFF	ON	ON	Cameras 849-864
55	OFF	ON	ON	OFF	ON	ON	Cameras 865-880
56	ON	ON	ON	OFF	ON	ON	Cameras 881-896
57	OFF	OFF	OFF	ON	ON	ON	Cameras 897-912
58	ON	OFF	OFF	ON	ON	ON	Cameras 913-928
59	OFF	ON	OFF	ON	ON	ON	Cameras 929-944
60	ON	ON	OFF	ON	ON	ON	Cameras 945-960
61	OFF	OFF	ON	ON	ON	ON	Cameras 961-976
62	ON	OFF	ON	ON	ON	ON	Cameras 977-992
63	OFF	ON	ON	ON	ON	ON	Cameras 993-1008
64	ON	ON	ON	ON	ON	ON	Cameras 1009-1024

SETTING UP A UNIT AS THE MASTER CLOCK

CAUTION: Switch 7 clears all entered data from memory.

DO NOT turn off the MDA before the reset process finishes. This can lock up the MDA and render it useless. The length of time to leave power on can vary from a few seconds to several min- utes (for systems with a lot of equipment). To determine when the process finishes, look at the monitor outputs as resetting puts everything back to default status.

You can synchronize several CM9760-MDAs even when connecting them without a CM9760 switching system. The master clock can be any unit ID as long as it is the first unit of the chain. Make it the master clock by turning on switch 8 of the unit ID DIP switch on the rear panel. This unit will synchronize the time and date of all units connected to it. Only one unit can be a master clock. The remaining units are the slave units (unit ID DIP switch 8 is in the OFF position, which is the default setting). A single MDA unit can provide the master time and date for up to 63 slave units.

RESETTING TO FACTORY DEFAULTS

You can reset the CM9760-MDA to factory defaults by turning on switch 7 of the UNIT ID DIP switch located on the rear panel. Do this before powering up the unit. Now, turn on the CM9760-MDA. This will clear all data stored in memory, such as titles and port configura- tions and resets them to the defaults as shipped from the factory. Then turn off the CM9760-MDA and turn switch 7 off.

Pelco Manual C573M-D (11/03) 9