Pelco cs73m-d operation manual SET Display

NOTE: Selecting both the Off option and the Global option causes all display settings for the current channel to be applied to all of the other 15 channels.

NOTE: If message text is set, the Position Text dialog box may indicate the posi- tion of message text rather than title/time/date text. For information about message text, refer to the Set Mes- sage Text section of this manual.

SET DISPLAY

The Display dialog box allows you to set the positions of the alphanumeric display (text location) for each camera input. In addition, you can adjust brightness through eight levels. You can also pickÑfor each camera inputÑwhat each of the four outputs associated with the input video will have for a display; that is, the alphanumeric display is ON or OFF for each of the four outputs.

To access the Display dialog box, click Edit on the CM9760-MDA SETUP dialog box and then click Display.

Figure 26. Display Dialog Box

At the top of the Display dialog box, you can set the unit ID and channel (camera) number. To set the unit ID, enter the unit ID number (1-64) and then press Return. To set the channel, enter the channel number (1-16) and then press Return. In addition, there is a Global option for title position, brightness, output on/off, and input on/off that allows all cameras of a unit to be set to the same state as the current channel. Also, there are five options: (display) Off, Position Text, Adjust Brightness, Output On/Off, and Input On/Off. The options are defined as follows:

Off	This option turns the setup display off for the program.
Position Text	This option sets the position of text; that is, where text will appear on
	all video outputs for the cameras selected that have the display option
	ON. To position text on an NTSC video display, click the NTSC option
	button (default setting). To position text on a PAL video display, click
	the PAL option button. Use the up arrow, down arrow, left arrow, and
	right arrow buttons to position the text on the video outputs. See
	Figure 27, Position Text Dialog Box. As adjustments are made, they
	appear in the blue screen at the bottom of the dialog box.
Adjust	The brightness level option for the text display ranges from 1 (darkest)
Brightness	to 8 (brightest). Use the up arrow and down arrow buttons to adjust
	brightness. See Figure 28, Adjust Brightness Dialog Box. As adjust-
	ments are made, they appear in the blue screen at the bottom of the
	dialog box.
Output On/Off	For each camera input, this option determines the output(s) (Out 1,
	Out 2, Out 3, Out 4) that will have an alphanumeric (text) display. A
	check-mark in the box turns on the output. See Figure 29, Output
	On/Off Dialog Box.
Input On/Off	This option gives you two selection boxes in which you can toggle
	time/date and titles on and off. A checkmark in the box turns on the
	selection. See Figure 30, Input On/Off Dialog Box.

32 Pelco Manual C573M-D (11/03)