JVC RX-554RBK manual Receiving Radio Broadcasts, Tuning in Stations Manually, Using Preset Tuning

English

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel only:

TUNER/BAND

1. Press TUNER/BAND.

The indicator above the button lights up.

Each time you press the button, the band alternates between FM and AM (MW/LW).

2. Press Control % / Þuntil “–TUNING+” appears on the display.

3.Press Control @/ # until you find the frequency you want.

• Pressing Control @ decreases the frequency.

• Pressing Control # increases the frequency.

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 40 stations at random.

To store the preset stations

On the front panel only:

1.Tune in the station you want to preset (see above). If you want to store the FM reception mode for this station, select the FM reception mode you want. See page 17 for details.

2. Press MEMORY. MEMORY

The channel number starts flashing on the display for about 5 seconds.

3.Press Control @ / #to select a channel number while the channel number position is flashing.

•Pressing Control @decreases the number.

•Pressing Control #increases the number.

4. Press MEMORY again while the selected channel	MEMORY
number is flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

Notes:

•When you hold down Control @ / # in step 3, the frequency keeps changing until you press Control @/ #again or a station is tuned in.

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

When an FM stereo program is received, the STEREO indicator also lights up.

CAUTION:

The preset channels may be erased in the following cases:

•When you press POWER to set it in the ÑOFF position.

•When you unplug the power cord.

•When a power failure occurs.

Note:

You can press 10 keys on the remote control to select a channel number in step 3, if you have pressed TUNER/BAND on the remote control prior to starting this preset procedures.

•For channel number 5, press 5.

•For channel number 15, press +10 then 5.

•For channel number 20, press +10 then 10.

•For channel number 30, press +10, +10, then 10.

15