Activating the Surround Sounds
English
Using the DAP Modes
You can use five DAP modes — “Dance Club, Live Club, Hall, Pavilion, and Headphones.” These modes (except “Headphones”) require the front speakers and the rear speakers, but do not require a center speaker to enlarge the sound field.
Among the DAP modes, “Headphones” is very special. It can create the same stereo sound as you listen through the speakers off air while listening to a source using headphones. So, you can feel as if you were not using the headphones and listening to music in a room.
On the front panel:
1. Press SURROUND so that the Control %/ Þ / @/ # buttons work for selecting the surround/DAP/3D- PHONIC modes.
The lamp above the button lights up.
2. Press Control % / Þuntil one of the DAP mode (“HEAD P,” “PAVILION,” “HALL,” “LIVE C,” or “DANCE C”) appears on the display.
Each time you press the button, the surround/DAP/3D- PHONIC modes change as follows:
SURROUND
Note:
When one of the DAP modes is selected, the DAP indicator also lights up on the display.
Ex. 
PROLOGIC 
THEATER 
3CHLOGIC 
OFF 
3DACTION* 
PAVILION* 
(One of the five modes appears)
*As for the
3.Press Control @/ # until the DAP mode you want appears on the display.
Each time you press the button, the DAP modes change as follows:
HEAD P 
PAVILION
| DANCE C |
| LIVE C |
| HALL |
|
|
|
|
|
| ||||
|
|
|
|
|
|
| |
HEAD Phones* | Gives a spacious stereo effect when listening with headphones. | ||||||
|
|
|
|
|
|
| |
PAVILION | Gives the spacious feeling of a pavilion with a high ceiling. | ||||||
|
|
|
|
|
|
| |
HALL | Gives clear vocal and the feeling of a concert hall. | ||||||
|
|
|
|
|
|
| |
LIVE Club | Gives the feeling of a live music club with a low ceiling. | ||||||
|
|
|
|
|
|
| |
DANCE Club | Gives a throbbing bass beat. | ||||||
|
|
|
|
|
|
|
|
*When you select “HEAD P,” you cannot go to the following steps. No adjustments can be made for “Headphones.”
ADJUST
4.Press ADJUST so that the Control % / Þ/ @/ # buttons work for adjusting the selected mode. The lamp above the button lights up.
5.Press Control %/ Þ until “– REAR +” appears on the display.
Note:
When changing the DAP modes to “PAVILION” or “HALL,” a reverberation sound comes out. This is because a long reverberation is applied to these two modes.
Note:
Once you have adjusted the DAP modes, the adjustment is memorized for each DAP mode.
29