Lucent Technologies 20 manual Checking status lights, Console setup

Page 14

Setup

Checking status lights

Checking status lights

Observe the activity pattern of the lights at the front of the CellPipe units to verify that they are connected properly.

Figure 2-3. Status lights

When all the cables are connected, verify that:

The pwr light comes on initially and remains on. If not on, make sure the power supply is properly connected.

The act light blinks during any LAN traffic. Otherwise it remains off.

The lnk light is on if there is an Ethernet connection established. If not on, check to make sure your Ethernet cable is properly connected.

The wan light blinks until a connection is established and then it remains on.

The con light is on only during the unit self-test.

Console setup

You need to set up a serial connection between the unit and your computer to access the command-line interface and configure a CellPipe 20 Series unit.

You need a 9-pin RS-232 serial cable to connect to the CellPipe unit through the console port.

You also need a terminal emulation program, such as HyperTerminal, PROCOMM PLUS, Zterm, or any other program that supports VT100 terminal emulation, to open a session directly with the unit.

2-4

CellPipe™ 20 Series User’s Guide

Image 14
Contents CellPipe 20 Series Lucent Technologies Finding information and software Customer ServiceCustomer Service Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP Lucent TURN-UPCellPipe 20 Series management Page Setup Verifying package contentsItems you need for installation Items you need for installationConnecting CellPipe 20 Series products Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsChecking status lights Console setupChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Using the commandsDisplaying information about a command Viewing the main menuSaving configurations Bridging commandsDisplaying second-level commands Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Configuring WAN interfaceSdsl commands and configurations Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interfaceConfiguring LAN interface in bridging mode Configuring LAN interface in routing mode Configuring the manage command Configuring the manage commandConfiguring the mode command Quick command in routing mode Configuring the quick commandQuick command in bridging mode Configuring the quick commandConfiguring the r1483 command Configuring the r1483 commandR1483 command in bridging mode R1483 command in routing mode Configuring the dnsrelay command Configuring the dnsrelay commandConfiguring the ipoa command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Obtaining software Preparing to upgradeUpgrading System Software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice