Lucent Technologies manual What is the CellPipe 20 Series Product Family?

Page 8

Introduction

What is the CellPipe 20 Series Product Family?

What is the CellPipe 20 Series Product Family?

The current CellPipe 20 Series Product Family consists of two groups of products—symmetrical digital subscriber line (SDSL) and asymmetrical digital subscriber line (ADSL)—for Point-to-Point Protocol (PPP) or Frame Relay over asynchronous transfer mode (ATM). All units support IP bridging and routing.

See Table 1-1 for a summary of the features for each product.

Table 1-1. CellPipe 20 Series products

	CellPipe units	Description

	CellPipe 20A-GX	Support for:
		• ADSL Annex A mode operation
		•	G.Lite interface
		•	DMT line code
		• IP routing and bridging, PPP support
		• Asymmetrical transmission with downstream
			rates of 64Kbps to 8Mbps and upstream rates of
			64Kbps to 1Mbps
		• One 10BaseT Ethernet port
		• Eight PVCs in bridging mode
		• Five PVCs in routing mode

	CellPipe 20S	Support for:
		•	SDSL transmission
		• IP routing and bridging, PPP support
		•	2B1Q line code
		• Symmetrical transmission rates in the range of
			144Kbps to 2.32Mbps
		• Integrated four-port 10BaseT Ethernet hub
		• Eight PVCs in bridging mode
		• Five PVCs in routing mode

1-2	CellPipe™ 20 Series User’s Guide

Image 8

Contents CellPipe 20 Series Lucent Technologies Customer Service Customer ServiceFinding information and software Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP Lucent TURN-UPCellPipe 20 Series management Page Setup Verifying package contentsItems you need for installation Items you need for installationConnecting CellPipe 20 Series products Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsChecking status lights Console setupChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Displaying information about a commandUsing the commands Viewing the main menuBridging commands Displaying second-level commandsSaving configurations Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Configuring WAN interfaceSdsl commands and configurations Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interfaceConfiguring LAN interface in bridging mode Configuring LAN interface in routing mode Configuring the manage command Configuring the manage commandConfiguring the mode command Configuring the quick command Quick command in bridging modeQuick command in routing mode Configuring the quick commandConfiguring the r1483 command Configuring the r1483 commandR1483 command in bridging mode R1483 command in routing mode Configuring the dnsrelay command Configuring the dnsrelay commandConfiguring the ipoa command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Obtaining software Preparing to upgradeUpgrading System Software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsWarranty repair Out-of warranty repairFCC Part 15 Notice FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice