Lucent Technologies 20 manual Routing commands

Page 22

Command-Line Interface

Routing commands

Table 3-1. Main menu and second-level bridging commands (continued)

Main menu	Second-level menus/description

r1483 (for adsl)	delpvc	- delete VPI and VCI
	pfilter	- set packet filter type
	setpvc	- set VPI and VCI for bridge mode
	setqos	- set class
	setspan	- <Enable><Disable> spanning tree
	show	- show RFC1483 configuration

r1483 (for sdsl)	delwanip	- delete VPI and VCI
	setqos	- set class
	setwanip	- set PVC and Wan IP for routing mode
	show	- show RFC1483 configuration

restart	reboot modem

save	save and restart modem

show	display configuration of PVC and Ethernet

ver	display software version

Routing commands

You have to preselect for routing mode to have the routing commands display. To select for routing, enter the mode command and then enter r to select routing.

>>mode

Please select bridge or router:(b/r,b)r

3-6	CellPipe™ 20 Series User’s Guide

Image 22

Contents CellPipe 20 Series Lucent Technologies Finding information and software Customer ServiceCustomer Service Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?CellPipe 20 Series management Lucent TURN-UPLucent TURN-UP Page Setup Verifying package contentsConnecting CellPipe 20 Series products Items you need for installationItems you need for installation Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsChecking status lights Console setupChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Using the commandsDisplaying information about a command Viewing the main menuSaving configurations Bridging commandsDisplaying second-level commands Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningSdsl commands and configurations Configuring WAN interfaceConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface in bridging mode Configuring LAN interfaceConfiguring LAN interface Configuring LAN interface in routing mode Configuring the mode command Configuring the manage commandConfiguring the manage command Quick command in routing mode Configuring the quick commandQuick command in bridging mode Configuring the quick commandR1483 command in bridging mode Configuring the r1483 commandConfiguring the r1483 command R1483 command in routing mode Configuring the ipoa command Configuring the dnsrelay commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Upgrading System Software Preparing to upgradeObtaining software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice