Lucent Technologies 20 manual Configuring the quick command, Quick command in bridging mode

Page 36

Configuring a 20 Series CellPipe

Configuring the quick command

>>mode

Please select bridge or router:(b/r,r) <br>

Configuring the quick command

The quick command allows you to easily configure your LAN connections in either the bridging or routing mode.

The quick command in bridging mode

The quick command in bridging mode allows you to easily configure eight PVCs. For example:

>>quick

1 PVC existed, 7 PVCs available.

VPI(0-1023):8

VCI (0-65535):33

Packet Filter (Any/Ip/Pppoe): any

Add another PVC ? (y/n): n

Enable Spanning tree? (y/n) : y

The quick command in routing mode

The quick command in routing mode allows you to select the connection protocol and set up the appropriate PVCs. For example:

>>quick

R1483(r)/ IPoA(i)/ PPPoA(p): r1483

0 PVC existed, 8 PVCs available.

Ethernet IP (149.198.65.46) :

Subnet mask (255.255.255.0) :

VPI(0-1023): 5

VCI(1-65535): 32

WAN IP : 149.198.6.46

Add another PVC ? (y/n): n

4-10	CellPipe™ 20 Series User’s Guide

Image 36

Contents CellPipe 20 Series Lucent Technologies Customer Service Customer ServiceFinding information and software Obtaining technical assistanceCustomer Service Contents Upgrading System Software Introduction About this guideWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP CellPipe 20 Series managementLucent TURN-UP Page Setup Verifying package contentsItems you need for installation Connecting CellPipe 20 Series productsItems you need for installation Connecting CellPipe 20 Series products CellPipe 20 Series rear panelsConsole setup Checking status lightsChecking status lights Console setup Page Command-Line Interface Syntax of command-line interfaceUsing the commands Displaying information about a commandUsing the commands Viewing the main menuBridging commands Displaying second-level commandsSaving configurations Bridging commandsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Configuring a 20 Series CellPipe Auto-provisioningConfiguring WAN interface Sdsl commands and configurationsConfiguring WAN interface Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interface in bridging modeConfiguring LAN interface Configuring LAN interface in routing mode Configuring the manage command Configuring the mode commandConfiguring the manage command Configuring the quick command Quick command in bridging modeQuick command in routing mode Configuring the quick commandConfiguring the r1483 command R1483 command in bridging modeConfiguring the r1483 command R1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa commandConfiguring the dnsrelay command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Preparing to upgrade Upgrading System SoftwareObtaining software Upgrading software Upgrading softwareProduct warranty Warranties and FCC RegulationsWarranty repair Out-of warranty repairFCC Part 15 Notice FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice