Lucent Technologies 20 manual Additional main-menu and second-level routing commands

Page 23

Command-Line Interface

Routing commands

The following main menu commands are displayed for routing mode:

xdsl*

- entry to xdsl menu

default

- set all configuration to factory setting

dnsrelay

- entry to DNS Relay menu

ipoa

- entry to IPoA menu

lan

- entry to Ethernet

list

- list status for enabled PVC

manage

- entry to management menu

mode

- exit this menu and change modem mode

pat

- entry to PAT menu

ping

- ping IP for testing purpose

pppoa

- entry to PPPoA menu

quick

- quick setup

r1483

- entry to RFC 1483 menu

restart

- reboot modem

rtable

- entry to Routing Table menu

save

- save and restart modem

show

- display configuration of PVC and Ethernet

ver

- display software version

Note: *The WAN interface displayed in the menu is dependent on the interface supported by your unit. This generic form of presentation has been arrived at to eliminate the need of representing every interface.

Most of the routing commands are similar to those under bridging mode. Table 3-2 lists only the additional routing commands and their corresponding second-level menus that appear when routing is selected.

Table 3-2. Additional main-menu and second-level routing commands

Main menu

Second-level menus/description

 

 

 

dnsrelay

setdnsip

- set DNS server IP

 

show

- show DNS Relay configuration

 

 

 

CellPipe™ 20 Series User’s Guide

3-7

Image 23
Contents CellPipe 20 Series Lucent Technologies Obtaining technical assistance Customer ServiceCustomer Service Finding information and softwareCustomer Service Contents Upgrading System Software About this guide IntroductionWhat is the CellPipe 20 Series Product Family? What is the CellPipe 20 Series Product Family?Lucent TURN-UP Lucent TURN-UPCellPipe 20 Series management Page Verifying package contents SetupItems you need for installation Items you need for installationConnecting CellPipe 20 Series products CellPipe 20 Series rear panels Connecting CellPipe 20 Series productsChecking status lights Console setupChecking status lights Console setup Page Syntax of command-line interface Command-Line InterfaceViewing the main menu Using the commandsDisplaying information about a command Using the commandsBridging commands Bridging commandsDisplaying second-level commands Saving configurationsMain menu Second-level menus/description Set all configuration to factory setting Routing commands Routing commandsAdditional main-menu and second-level routing commands Command-Line Interface Command-Line Interface Page Auto-provisioning Configuring a 20 Series CellPipeConfiguring WAN interface Configuring WAN interfaceSdsl commands and configurations Select the dbit command to configure the sdsl data bit Adsl commands and configurations Select the abort command to abort the Adsl connection Multimode Configuring LAN interface Configuring LAN interfaceConfiguring LAN interface in bridging mode Configuring LAN interface in routing mode Configuring the manage command Configuring the manage commandConfiguring the mode command Configuring the quick command Configuring the quick commandQuick command in bridging mode Quick command in routing modeConfiguring the r1483 command Configuring the r1483 commandR1483 command in bridging mode R1483 command in routing mode Configuring the dnsrelay command Configuring the dnsrelay commandConfiguring the ipoa command Configuring the pppoa command Configuring the pppoa commandConfiguring the pat command Configuring the pat commandSelect the show command to display the Pat configuration Obtaining software Preparing to upgradeUpgrading System Software Upgrading software Upgrading softwareWarranties and FCC Regulations Product warrantyFCC Part 15 Notice Warranty repairOut-of warranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice